Atlantic Ultraviolet MIN-9 Owner's Manual - Page 17

Browse online or download pdf Owner's Manual for Water Filtration Systems Atlantic Ultraviolet MIN-9. Atlantic Ultraviolet MIN-9 20 pages. Germicidal ultraviolet water purifiers
Also for Atlantic Ultraviolet MIN-9: Owner's Manual (16 pages), Owner's Manual (16 pages)

Print Page

TROUBLESHOOTING

WARNING: Always disconnect power to the water purifier before performing any service or maintenance.

IMPORTANT: This unit is to be serviced ONLY by qualified, and appropriately licensed, personnel.

Problem

Purifier not operating

Water leaking into/from purifier.

Poor purifier performance.

. 10-0508B

ALLAST

If power is applied to the ballast without a lamp connected to the circuit or if the lamp fails, the ballast's lamp-out protection

will prevent the ballast from operating, and a red LED light will illuminate and audio alarm will sound. To reset: disconnect the

ballast from power and reconnect or replace the lamp. The ballast must remain disconnected from power for (2) minutes to

reset. After 2 minutes restore input power, ballast should resume proper operation.

WARNING: The equipment that this ballast is used with requires connection to a known good ground. It is the User's

responsibility to insure that their equipment is properly grounded in compliance with the National Electrical Code and

any applicable local codes. Equipment wiring and hook up should be performed by a qualified, licensed electrician.

Failure to comply with this requirement could result in serious injury or death

Table 3 - Troubleshooting

Possible Cause

No electrical power....

Cracked or broken quartz sleeve...

Quartz sleeve sealing o-ring(s) worn,

damaged...

Poor, or loose, connections or fittings

Quartz sleeve fouled...

Germicidal lamp output depreciating...

Germicidal lamp not functioning...

Low input voltage...

Change in water quality....

HAS

AMP

OUT

ROTECTION

Corrective Action

Verify that the purifier is connected to a live power

source.

Shut down purifier, drain, and replace quartz

sleeve. See "Replacement of Broken Quartz

Sleeve" in the "Maintenance" section

Shut down purifier, drain, and remove static gland

nut, replace sealing o-ring. See "Quartz Sleeve

Installation, Cleaning or Replacement" in the

"Maintenance" section

Tighten suspect connection or fitting; or shut down

purifier, drain, and remove fitting or connection.

Clean threads; reapply thread sealing tape and

reinstall.

Clean quartz sleeve, see "Quartz Sleeve

Installation, Cleaning or Replacement" Section.

Replace lamp, as it nears its end of life (EOL).

See "Lamp Installation or Replacement" in the

"Maintenance" section.

Replace lamp. See "Lamp Installation or

Replacement" in the "Maintenance" section

Verify input voltage to purifier.

Have water tested to confirm that it does not

exceed maximum recommended concentration

levels for use with this purifier.