Atlantic Ultraviolet Sanidyne User Manual - Page 4

Browse online or download pdf User Manual for Accessories Atlantic Ultraviolet Sanidyne. Atlantic Ultraviolet Sanidyne 12 pages. Portable area sanitizer
Also for Atlantic Ultraviolet Sanidyne: Installation Operation & Maintenance (16 pages)

Print Page

3. SET-UP PROCEDURE

3.1

Disconnect power cord.

3.2

Remove protective storage cover by loosening the four thumb screws on the top of the unit.

3.3

Install lamps

3.3.1 Holding the lamp vertically by its base, carefully insert the U-bent section of tube into a slot

in the top assembly of the unit. To prevent breaking the lamp, keep the lamp base to one

side of the socket below.

3.3.2 Align the connector pins on the lamp base with the socket below.

3.3.3 Carefully insert the lamp in the socket.

3.3.4 Install the remaining three lamps.

3.4

Connect the power cord.

3.5

Test unit

3.5.1 Replace the storage cover and secure by tightening the thumb screws.

3.5.2 Put on protective gloves and full face shield (provided).

3.5.3a 120v: On the 3-hour timer, turn white knob clockwise to set arbitrary time and press button

in center. Operation indicator light on base of unit should be lit, signifying that the

disinfection cycle has begun.

3.5.3b 230v: On the 3-hour timer, turn the setting dial clockwise to set arbitrary time, place the

ON/OFF rocker switch in the ON position. Output indicator (OUT) should light and the

power indicator (POWER) should be flashing.

3.5.4 Ensure that all four lamps are lit through the observation windows in the cover.

3.5.5 Replace the protective storage cover when the unit is not in use.

4. APPLICATIONS

Typical applications for the Sanidyne

• Operating rooms

• Homeless shelters

5. OPERATION

5.1

Determine treatment time for the area to be disinfected by referring to the attached chart.

5.1.1 Read the longest room dimension on the horizontal axis.

5.1.2 Follow an imaginary vertical line through this point and note where the heavy black line is

intercepted.

5.1.3 At this point, follow an imaginary horizontal line to the vertical axis on the left and read the

corresponding treatment time in minutes.

5.2

Set the unit on a cleared table or on the floor in the center of the room to be treated. (Treatment

is most effective when the unit is in the vertical center of the room and the ultraviolet rays are

unobstructed.)

5.3

Connect power to the unit and remove the protective storage cover.

5.4

120v: On the 3-hour interval timer, turn the white knob clockwise to set treatment time. Press

button in center of timer to start. Operation indicator light will come on.

230v: On the 3-hour timer, turn the setting dial clockwise to set treatment time, place the

ON/OFF rocker switch in the ON position. Output indicator (OUT) should light and the

power indicator (POWER) should be flashing.

5.5

Leave area quickly (within three minutes) to avoid ultraviolet exposure.

5.6

Post the warning sign outside the entrance to the area being treated and notify the appropriate

personnel that the area should not be entered until the disinfection cycle is complete.

5.7

230v: Once the timer cycle is complete; the lamps should shut-off, output indicator (OUT) should

shut-off and the power indicator (POWER) should remain on without flashing.

Always switch unit OFF when treatment is finished.

Portable Area Sanitizer include the following:

• Patient rooms

• Auditoriums

• Laboratories

• Gymnasiums

• Clean rooms

• Morgues