Electrolux RS-600 Installation And User Manual - Page 5

Browse online or download pdf Installation And User Manual for Ventilation Hood Electrolux RS-600. Electrolux RS-600 5 pages.

Print Page

•

Hang the chimney (2) on the lower bracket (4) (fig. ). Fix the

upper chimney (2) on the upper bracket (3), and secure on

both sides with the 2 remaining short screws (9) (fig. ).

•

Fine tune the chimney height, and tighten all screws. Check

tight fit of all parts.

Bridging larger distances

•

Bridging larger distances to the outdoors can be achieved by

installing an external motor inside the exhaust duct. To do

this, consult an electrician.

Installation without exhaust duct

•

If you do not have an outlet to the outside, the exhaust pipe

is not required and the installation is similar to the one shown

in the Installation with exhaust duct section.

6. OPERATION

•

Switch on the appliance at the switched fused connection

unit. The appliance is ready for operation.

Functions

Switch

Function

Appliance off

Low speed (pilot lamp lit)

Medium speed (pilot lamp lit)

High speed (pilot lamp lit)

Switching light on/off

7. MAINTENANCE

•

Before cleaning, switch the appliance off and disconnect the

cooker hood from power supply.

•

Clean the appliance in the following intervals:

Use a soft cloth moistened with hand-warm mildly

soapy water or household cleaning detergent. Never

use metal pads, chemical, abrasive material or stiff

brush to clean the appliance.

Metallic anti-grease filter: The filter collects grease,

smoke and dust so the filter is directly affecting the

efficiency of the cooker hood. If not cleaned, the

grease residue (potential flammable) will saturate on

the filter. Clean it with household cleaning detergent.

Important: Clean the filter every month to

prevent risk of fire.

RS-600 (CHS60SS)-GB-05.indd 5

Light bulb replacement

The lighting system fitted to the hood is just a

supportive light. In any case, it can not substitute for

the main lighting in the kitchen.

•

Switch the appliance off and disconnect the power supply.

•

In order to replace light bulbs, both metallic anti-grease filters

should be detached first.

•

Press the locks and pull the filters downward.

•

Screw one or both of the light bulbs from the holder and

replace by new light bulb(s) of the same type, max. 40W

(E14).

•

Replace the metallic anti-grease filters and make sure they

lock in place.

8. TROUBLESHOOTING

Fault

Cause

The appliance is

not hung properly

on the brackets.

Excessive

vibration.

The fan blade is

damaged.

The fan motor is

not fixed tightly.

The fan blade is

jammed.

Light on, but fan

does not work.

The motor is

damaged.

Light bulb broken.

Both light and fan

do not work.

Power connection

loose.

Distance between

the appliance and

the cooking place

Suction

too large.

performance

not good.

Metallic anti-

grease filter is dirty.

9. TECHNICAL DATA

Power supply

Power consumption – Fan

Power consumption – Luminary :

Power consumption – Total

Protection class

Light bulb

10. ENVIRONMENTAL PROTECTION

Waste electrical products should not be disposed of

with household waste. Please recycle where facilities

exist. Check with your Local Authority or retailer for

recycling advice.

Solution

Take down the

appliance and

check it is properly

fixed.

Switch off the

appliance. Repair

to be carried out

by qualified service

personnel only.

Replace with a

bulb with correct

rating.

Check power

supply.

Readjust the

distance to:

Gas cookers:

70cm

Electric cookers: 66cm

Coal/oil cookers: 8 0cm

Clean filters (see

Maintenance

chapter).

220-240V~ 50Hz

140W

2 x 40W

220W

Max. 40W (E14)

6/8/2010 9:31:04 AM