• Do not use the appliance if the water tank has not been filled.
EN
EN
• Do not use the appliance without the drip tray or drip grid, unless a higher cup/mug is in use.
• Do not use or place the appliance on a hot surface or near source of heat.
CNT
• Warning: Avoid spillage on the connector.
• This appliance is intended for domestic use only. The manufacturer cannot accept any liability for possible
damage caused by improper or incorrect use.
• This appliance is not intended to be operated by means of an external timer or separate remote-control
system.
This appliance is for used in household and similar applications such as:
– staff kitchen areas in shops, offices and other working environments;
– farmhouses;
– used by clients in hotels, motels and other residential type environments;
– bed and breakfast type environments.
GETTING STARTED (picture page 3 and 4)
Start the machine for the first time
1. Place the machine on a flat surface. Plug in the machine to turn on its stand-by mode, with
turns half on. Fill the tank with cold pure water. Put filter cup into filter handle, and then secure it onto
brewing head anti-clockwise from "INSERT" to "LOCK" position without coffee. Make sure the knob is
at the horizontal position ("OFF" position).
2. Start the machine with
3. When buttons stop blinking, pre-heating is done. Press
There may be noise when pumping the water for the first time. It is normal. The machine is releasing
the air from inside. The noise will stop after about 20 seconds.
4. When brewing is finished, remove the filter handle clockwise, clean the filter and the drip tray. Now the
machine is ready to use. NOTE: The machine will turn off automatically after 20 mins of no operation.
Make espresso coffee
5. Put one-cup filter cup into filter handle. Add one spoon of ground coffee, press it tight with tamper; or
add an E.S.E pod and put it into filter cup. E.S.E (Easy Serving Espresso) Pods can be used to simplify
the espresso preparation. Each pre-packed pod contains 7 grams of coffee, already measured,
pressed and sealed between 2 fine layers of filter paper.
6. Attach the filter holder onto the brewing head in anti-clockwise direction from "INSERT" to "LOCK"
position.
7. Put a warm cup on the drip tray. When pre-heating is done,
press
8. The machine will stop operation when the brewing is done.
9. To brew 2 cups of espresso at the same time, press
10. NOTE: If both
cancel brewing, or (step 11)
11. (step 10) you may restart brewing after cooling down the boiler. Turning the knob to
release hot water from steam nozzle. The pump stops working automatically when it has cooled down.
Turn the knob off and resume brewing.
Make hot water
12. When pre-heating is done,
Hot water will flow out from the steam nozzle. Turn the knob off when you get the needed amount.
www.electrolux.com
button, with light turns fully on and
button to start brewing process.
and
buttons start blinking quickly, you may simply press
and
button to start brewing process. NOTE:
and
button.
and
buttons fully light up, turn the knob to
and
buttons start blinking.
and
buttons fully light up,
or
button to
position to
button
position.
6
Print Page