Electrolux WHGL9040CN Manual - Page 34

Browse online or download pdf Manual for Ventilation Hood Electrolux WHGL9040CN. Electrolux WHGL9040CN 40 pages.
Also for Electrolux WHGL9040CN: Installation Manual (12 pages), Installation Manual (12 pages), Manual (21 pages)

Print Page

34 www.electrolux.com

INSTALLATION

Wall drilling and bracket fixing

Wall marking:

• Draw a vertical line on the supporting wall

up to the ceiling, or as high as practical, at

the centre of the area in which the hood

will be installed.

• Draw a horizontal line at 650 mm above

the hob.

• Place bracket 7.2.1 on the wall as shown

about 1-2 mm from the ceiling or upper

limit aligning the centre with the vertical

reference line.

• Mark the wall at the centres of the holes in

the bracket.

• Place bracket 7.2.1 on the wall as shown

at X mm below the first bracket (X = height

of the upper chimney section supplied),

aligning the centre with the vertical line.

• Mark the wall at the centres of the holes in

the bracket.

• Mark a reference point as indicated at 116

mm from the vertical reference line and

330 mm above the horizontal reference

line.

• Repeat this operation on the other side.

• Drill ø 8 mm holes at all the centre points

marked.

• Insert the wall plugs 11 in the holes.

• Fix the lower bracket 7.2.1 using the 12a

screws (4,2 x 44,4) supplied.

• Fix the upper bracket 7.2.1 (and, in case

of hood installation in recycling version,

the air outlet connection 15) using the 2

screws 12a (4,2 x 44,4) supplied.

• Insert the two screws 12a (4,2 x 44,4)

supplied in the hood body fixing holes,

leaving a gap of 5-6 mm between the wall

and the head of the screw.

7.2.1

116

12a