Electrolux # Service Manual - Page 26

Browse online or download pdf Service Manual for Vacuum Cleaner Electrolux #. Electrolux # 49 pages. Over the range microwave oven
Also for Electrolux #: Installation Instructions Manual (8 pages), Use & Care Manual (20 pages), Use & Care Manual (36 pages), Use & Care Manual (24 pages), Use & Care Manual (38 pages), Recipe Book (17 pages), Instruction Booklet (12 pages), Use & Care Manual (20 pages), Instruction Book (16 pages), Instruction Book (12 pages), Insrtuction Manual (16 pages), User Manual (11 pages), Use & Care Manual (26 pages), Use & Care Manual (38 pages), Owner's Manual (9 pages), Use And Care Manual (16 pages), Use And Care Manual (16 pages), Installation Instructions Manual (21 pages), Owner's Manual (16 pages), Use And Care Manual (16 pages)

Print Page

GLMV169GSB

GLMV169GBB

GLMV169GQB

PLMVZ169GCB/C

() Disconnect the power supply cord, and then remove outer case.

(2) Open the door and block it open.

(3) Discharge high voltage capacitor.

(4) Disconnect the sensor connector that is mounted to control panel.

(5) Then connect the dummy resistor circuit (see fig.) to the sensor connector of control panel.

(6) Disconnect the leads to the primary of the power transformer.

(7) Ensure that these leads remain isolated from other components and oven chassis by using insulation

tape.

(8) After that procedure, re-connect the supply.

(9) Check the sensor cook operation proceed as follows:

9-. Touch Sensor reheat pad once and touch the Start pad.

9-2. The control panel is in the sensor cooking operation.

9-3. After approximately 32 seconds, push plunger of select switch for more than 3 seconds. This

condition is same as judgement by AH sensor.

9-4. After approximately 3 seconds, the display shows " X X . X X " which is the remaining cooking

time, and the display count down.

If the above is not the case, the control unit is probably defective.

If the above is proper, the AH sensor is probably defective.

(0) Disconnect the power supply cord, and then remove outer case.

() Open the door and block it open.

(2) Discharge high voltage capacitor.

(3) Disconnect the dummy resistor circuit from the sensor connector of control panel.

(4) Carry out necessary repair.

(5) Reconnect all leads removed from components during testing and repairing.

(6) Re-install the outer case (cabinet).

(7) Reconnect the power supply cord after the outer case installed. Run the oven and check all function.

(8) Carry out "Water load cooking test" again and ensure that the oven works properly.

To connector (F)

on Control Unit.

F-1

F-2

F-3

CHECKING CONTROL UNIT

Ω ±

R1, R2 : 22

Ω ±

R3 : 4.3k

Ω ±

R4 : 1M

CONNECTOR

Sensor Dummy Resistor Circuit

1% 1/2W

5% 1/4W

COM

COM NO

Plunger