Atlantis A08-OLS60 Quick Start Manual - Page 2

Browse online or download pdf Quick Start Manual for Barcode Reader Atlantis A08-OLS60. Atlantis A08-OLS60 2 pages.

Print Page

Introduction

The Quick Guide contains only part of programming

barcode labels that are often used, and is for

omnidirectional scanners with single-line scan mode

only. (A08-OLS60, A08-OLS60-H)

Please see the following instructions to program your

scanner.

Locate the single-line switch button on your

scanner. It can be used to emit a single line

pattern to scan the labels contained in this guide.

Single-line switch button

Press the single-line switch button to scan the

Enter/Exit programming label.

Scan all necessary labels to configure the scanner

for your application.

Scan the Enter/Exit programming label again to

save the changes.

The scanner must be properly powered before

programming. During the programming mode, the laser

scanner will acknowledge a good and valid reading with

a short beep. It will give long beeps for either an invalid

or bad reading.

Detailed instructions and safety notices please refer to

your User's Manual.

Important Notice

No warranty of any kind is made in regard to this

material, including, but not limited to, implied

warranties of merchantability or fitness for any

particular purpose.

Laser Safety

The laser scanner complies with CDRH Class IIa and

the IEC 60825-1: Class 2. The scanner contains

internally a Visible Laser Diode (VLD) whose emissions

do not exceed the maximum limits as set forth in the

above regulations. Class lla and Class 2 products are

not considered to be hazardous to human.

Enter/Exit programming

All program setup must start and

end with reading this barcode to

save any changes.

The reading of the "RESET" label

turns all the parameters back to

default values.

Reset

The reading of the "ABORT" label

discards all the parameters read

prior to the "End of configuration".

Abort

The reading of the "SHOW

VERSION" label will show the

firmware version.

Version

USB Mode

The USB mode is effectively a keyboard emulator works with

hosts that are USB-compatible operating systems and have USB

ports. USB compatible operating systems are Windows 98,

Windows NT 5.0 and Mac OS 8 and later, no additional software

is needed since the USB driver support is built into this operating

system.

Message Terminator

None

H Tab

Keyboard Wedge Mode

Message Terminator

None

Enter

The factory default communications are: 9600 baud, 8 data bits,

mark parity, 1 stop bit, and CR/LF terminator message.

19200

4800

1200

Even

Mark

Enter

None

Hor. Tab

H Tab

Execute

EOT

RS-232 Mode

Baud Rate

9600

2400

600

Data Bit

Stop Bit

Parity

Odd

Space

Message Terminator

CR/LF

STX/ETX