Drill Master 61311 Owner's Manual & Safety Instructions - Page 6

Browse online or download pdf Owner's Manual & Safety Instructions for Sander Drill Master 61311. Drill Master 61311 12 pages. 120 volt orbital hand sander

Print Page

5. If you are using one extension cord for more

than one tool, add the nameplate amperes

and use the sum to determine the required

minimum cord size. (See table a.)

6. If you are using an extension cord outdoors, make

sure it is marked with the suffix "W-A" ("W" in

Canada) to indicate it is acceptable for outdoor use.

7. Make sure the extension cord is properly wired

and in good electrical condition. Always replace

a damaged extension cord or have it repaired

by a qualified electrician before using it.

8. Protect the extension cords from sharp objects,

excessive heat, and damp or wet areas.

Symbology

Double Insulated

Volts

Alternating Current

Amperes

No Load Revolutions

n 0 xxxx/min.

per Minute (RPM)

Page 6

For technical questions, please call 1-888-866-5797.

taBLE a: rEcOMMEnDED MiniMuM WirE

GauGE FOr EXtEnSiOn cOrDS* (120/240 VOLt)

EXtEnSiOn cOrD

naMEpLatE

aMpErES

25´

(at full load)

0 – 2.0

2.1 – 3.4

3.5 – 5.0

5.1 – 7.0

7.1 – 12.0

12.1 – 16.0

16.1 – 20.0

* Based on limiting the line voltage drop to five volts at

150% of the rated amperes.

WARNING marking concerning Risk

of Eye Injury. Wear ANSI-approved

safety goggles with side shields.

Read the manual before

set-up and/or use.

WARNING marking

concerning Risk of Fire.

Do not cover ventilation ducts.

Keep flammable objects away.

WARNING marking concerning

Risk of Electric Shock.

Properly connect power cord

to appropriate outlet.

LEnGtH

50´

75´ 100´ 150´

Item 61311