Atlas AA100PHD Owner's Manual - Page 10
Browse online or download pdf Owner's Manual for Amplifier Atlas AA100PHD. Atlas AA100PHD 20 pages. Mixer amplifier
Print Page
Rear Panel
15. Multi Function DIP switch
1
2
3
Zone 2 Assign
Input 3
Input 2
Input 1
Off
Off
Off
On
On
On
Switch B
•
DP SW #1 - Mute Receive Input 4 - When "ON" , Input 4 signal will be muted if a signal is present on Input 1 or if the Remote
Mute Terminals are shorted together.
•
DP SW #2 - Mute Receive Input 3 - When "ON" , Input 3 signal will be muted if a signal is present on Input 1 or if the Remote
Mute Terminals are shorted together.
Amp In
•
DP SW #3 - Mute Receive Input 2 - When "ON" , Input 2 signal will be muted if a signal is present on Input 1 or if the Remote
Mute Terminals are shorted together.
•
DP SW #4 - Input 2 Phantom Power 24VDC is active when Input 2 is set to Mic mode and the switch is in the ON position.
Note: Only use this feature if you are using condenser microphones, otherwise leave in the "OFF" position.
•
DP SW #5 - When in the "MIC" position, Input 2 will accept microphone level signals; when in the "Line" position, Input 2 will
accept line level or telephone signals.
25V 70V
•
DP SW #6 - Input 1 Phantom Power 24VDC is active when Input 1 is set to Mic mode and the switch is in the ON position.
Note: Only use this feature if you are using condenser microphones, otherwise leave in the "OFF" position.
•
DP SW #7 - When in the "MIC" position, Input 1 will accept microphone level signals; when in the "Line" position, Input 1 will
accept line level or telephone signals.
•
DP SW #8 - RIS (Remote Input Select) activates the RIS terminals when in the ON position. When the RIS is active, NO input
will be present at the amplifier output unless the RIS input port pins are shorted to ground. See RIS ports.
16. Amplifier Outputs
Pre Out
For loudspeaker connections, connect as follows or proceed to the setup section for typical wiring schemes.
•
COM - Speaker common or negative connection
•
4Ω - Connect to direct coupled loudspeakers
•
25V - Connect to transformer coupled loudspeakers
•
70V - Connect to transformer coupled loudspeakers
17. Power Cord
Connect this grounded power cord to 120VAC circuits only. Serious damage may result otherwise.
18. Ground Terminal
Connect this terminal to electrical ground as required by local codes.
3
5
4
6
3
7
AtlasSound.com
2
1
AA100PHD
100W Mixer Amplifier
4
1
2
Mute RCV
Input 4
Input 3
Off
Off
Off
On
On
On
Bass
Treble
Sum In
Sum In
Chan 4
Chan 3
4
5
4
6
3
8
2
9
1
3
4
5
Input 2
Input 2
Phantom
Phantom
Off
Off
Line
On
On
Mic
Input 2
G – +
Channel 2 - Input
Signal
Limiter
Master Level
1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A.
5
4
Telephone: 800.876.3333 • Fax: 800.765.3435
7
3
– 10 –
8
2
9
1
Owner's Manual
6
7
8
Input 1
RIS
Off
Line/Tel
On
On
Mic
Off
Inputs
Remote Input
2,3,4
1
Select (RIS)
G
10V 4 3 2 GND
Return
Remote Level
+
G –
RMT
Mute
Channel 1 - Input
Fault
Power
6
Power
7
8
9
RIS
–
+
VOX
Sens
PHD