Atlas PA702 Owner's Manual - Page 7

Browse online or download pdf Owner's Manual for Amplifier Atlas PA702. Atlas PA702 16 pages. 2-channel 70w power amplifier
Also for Atlas PA702: Brochure & Specs (10 pages)

Print Page

ATLAS SOUND PA702, 2-CHANNEL 70W POWER AMPLIFIER

FUSE

Rear Panel

IEC AC Receptacle

Connect this grounded power cord to 120VAC circuits only. Serious damage may result otherwise.

AC Mains Fuse

For 100v – 120v operation use Slow Blow T3.15A 250v, 5mm x 20mm.

UNSWITCHED OUTLET

The un-switched outlet provides power for other devices such as video projectors, CD players or laptop

computers. This AC outlet is live all the time as long as the power cord is plugged into a live duplex outlet.

Keep the total power draw below 500W. This outlet can also be used to remotely turn on the PA702. See AC

Sense Trigger for more detailed information (page 9).

RCA Input

Unbalanced signals are accepted when using the Left and Right RCA connectors. Note:On the bottom of the

chassis there are level controls for the for the Left and Right RCA inputs. This allows you to adjust the level

from OFF to +6dB. Factory settings calibrated for 320mv of input sensitivity. See Mixer Function page 9 for use.

Balanced Input Connections

Left and Right balanced input signals can be accomplished by wiring the removable Phoenix type connector

per the labeling on the rear of the amp. Note: The middle pin is the common ground connection for both Left

and Right input ground. For unbalanced signals connect the (–) and (GND) pins together.

Speaker Connections

A removable Phoenix type connector is supplied to connect your speakers to the PA702. It is recommended

to use 16guage wire or higher for connection to the speaker. Note: Do not overload the amp by connecting to

many speakers to the amp. Four ohms per channel is the maximum load.

Four Position Dip Switch Assignment

Switch 1 - Sense On / Off

Audio or AC trigger. When the switch is in the "UP" position, all trigger circuits are bypassed. The only way

to turn the amp On or Off is via the mains AC Power Switch located on the front panel. When in the "DOWN"

position either the Audio or AC Sense turn on Triggers is activated. See switch 2 for selection.

1601 JACK MCKAY BOULEVARD ENNIS, TEXAS 75119 U.S.A. •

, this switch activates the PA702 remote turn on sensing circuits via either

Specifications are subject to change without notice

AtlasSound.com

Printed in China

OWNER'S MANUAL

TELEPHONE: (800) 876-3333 • FAX: (800) 765-3435

ATS002604 RevA 03/07