Atlas STRATEGY SERIES II FAP42TC General Description - Page 3

Browse online or download pdf General Description for Speaker System Atlas STRATEGY SERIES II FAP42TC. Atlas STRATEGY SERIES II FAP42TC 3 pages. 4" speaker systems

Print Page

The loudspeaker system shall be Atlas Sound FAP42TC. System

shall include a high performance 4" coaxial loudspeaker, low profile

enclosure and press-fit grille for conventional ceiling installation.

Frequency response for the system shall be 75Hz to 20kHz (±7dB).

Sensitivity shall be 88dB average. Loudspeaker shall be comprised

of an 4" coaxial cone type driver. Cone shall be constructed of

polypropylene with a butyl rubber surround. The19mm tweeter shall

be constructed of PEI. Magnet shall be a minimum of 10oz. (264g)

and the voice coil diameter shall be 1" (25mm).

Transformer shall be (70.7/100V) volt type with 1, 2, 4, 8 and 16 watt

primary taps (@70.7V) with a front mounted tap selector switch to

include transformer bypass setting for 8 ohm direct coupled operation.

Enclosure shall be constructed of deep drawn steel. Internal volume

shall be 134 cubic inches. To facilitate connection in conduit systems,

enclosure shall be equipped with an access panel covering a

recessed terminal cup. This cover shall provide a combination 3/4"

(19mm inside diameter) / 1" (25mm inside diameter) knock-out to

conduit.

1601 JACK MCKAY BLVD. / ENNIS, TEXAS 75119 U.S.A.

TELEPHONE: (800) 876-3333 / FAX (800) 765-3435

ARCHITECT AND ENGINEER SPECIFICATIONS

Specifications subject to change without notice

Printed in U.S.A.

External wiring shall be accomplished via wiring connector with screw-

down terminals to provide secure wire termination. The connector

shall facilitate in/out wiring and shall be located in the recessed area

behind the conduit access panel.

Seismic support eye shall be provided for an additional suspension

point when used in drop tile ceilings. Construction of enclosure shall

be a minimum of 18 gauge deep drawn galvanized metal.

The system shall include a support backing plate to reinforce the

ceiling material and tile support rails for use on either 2' x 4' (609

x 1219mm) or 2' x 2' (609 x 609mm) suspended ceiling tiles. This

assembly can all be installed from beneath the ceiling tile. Overall

front face diameter shall not exceed 10.5" (267mm); overall depth

from the bottom of bezel to top of enclosure shall not exceed 4.24"

(108mm).

Grilles shall be press-fit, manufactured from 24 gauge perforated steel

mesh and finished in white epoxy. Round grill shall be 8.49" (216mm)

Diameter.

The loudspeaker shall weigh no more than 5.4 lbs (2.45kg).

The loudspeaker shall be the Atlas Sound FAP42TC.

AtlasSound.com

001004

ATS001871 RevB 10/04

2.67

SL1-2049