Bosch Series 4 Instruction Manual - Page 12

Browse online or download pdf Instruction Manual for Vacuum Cleaner Bosch Series 4. Bosch Series 4 50 pages. Free standing cooker
Also for Bosch Series 4: Instruction Manual (24 pages), Instruction Manual (44 pages), Instructions For Installation And Use Manual (16 pages), Instructions For Installation And Use Manual (16 pages), Instruction Manual (16 pages), Instruction Manual (24 pages), Instruction Manual (10 pages), Instruction Manual (12 pages), Instruction Manual (20 pages), Instruction Manual (32 pages), Installation Instructions Manual (12 pages), Manual (2 pages), Quick Reference Manual (2 pages), User Manual (16 pages), Information For Use (24 pages), Instruction Manual (48 pages), Information For Use (32 pages), Information For Use (32 pages), User Manual (32 pages), Information For Use (32 pages), Instruction Manual (24 pages), Instructions For Use Manual (27 pages), User Manual And Installation Instructions (40 pages), Information For Use (32 pages), Instruction Manual (36 pages), User Manual (24 pages), Instructions For Use Manual (47 pages), User Manual And Installation Instructions (28 pages)

Print Page
Bosch Series 4 Instruction Manual
en Water softening system/special salt
+
Water softening
system / special salt
T o ensure good rinsing results, the
W a t e r s o f t e n i n g s y s t e m / s p e c i a l s a l t
dishwasher requires soft water, i.e.
water which is low in lime, otherwise
limescale will be deposited on the
utensils and interior container. Tap
water above 7° dH (1.2 mmol/l) must
be softened. The water is softened with
special salt (regeneration salt) in the

water softening system

of the dishwasher. The setting and
therefore the required amount of salt
depends on the degree of hardness of
your tap water (see following water
hardness table).

Water hardness table

12
Adjusting the water softening
system
You can set the amount of salt that
should be added to a value between
•:‹‹ and •:‹ˆ. No salt is needed with
the setting •:‹‹.
Here's how to set up the amount of
added salt:
Ask your local water utility company
1.
for the water hardness value of the
tap water.
Required setting can be found in the
2.
water hardness table.
Switch on ON/OFF switch (.
3.
Hold down the programme button
4.
# and then repeatedly press the
START button P until •:‹...
appears in the display window.
Release both buttons.
5.
The LED of the # button flashes
and the digital display )" shows
the factory setting •:‹....
Press the programme button 3.
6.
Each time the button is pressed, the
set value increases by one level;
when it reaches the value •:‹ˆ the
display jumps back to •:‹‹ (Off).
Press START button P.
7.
The chosen setting has now been
stored in your dishwasher.