Bose Panaray LT 9402TM WR Service Manual - Page 25

Browse online or download pdf Service Manual for Speakers Bose Panaray LT 9402TM WR. Bose Panaray LT 9402TM WR 27 pages. Weather resistant

Print Page

High Frequency Compression Driver Diaphragm Replacement Procedure

The compression driver diaphragm is replaceable using a kit, part number 276861. Perform the

steps below.

1. Remove the compression driver using the disassembly procedures for the Panaray

speaker

you are repairing.

2. Place the driver on a flat surface. Using an allen head wrench, remove the three cap screws

that secure the driver cover in place. Lift it off.

3. Note the alignment of the diaphragm assembly and lift it straight off of the magnet assembly.

4. Ensure that there is no dirt or debris in the magnet gap. Insert a small piece of clean paper

into the gap and work it around the perimeter of the gap to ensure that it is clean. Blow any

debris out of the gap with dry compressed air, if available.

5. Align the replacement diaphragm with the magnet assembly. Carefully slide the voice coil into

the gap of the magnet assembly. Take care not to damage the voice coil.

6. Ensure that the rubber gasket on the compression driver cover is properly aligned to provide

an airtight seal. Align the cover with the diaphragm and slide it into place.

7. Secure the compression driver cover in place using the three allen head cap screws removed

in step 2. Torque them in the following sequence; clockwise to 5 inch lbs, counter-clockwise to

15 inch lbs and clockwise to 25 inch lbs.

8. Re-install the compression driver into the cabinet. Observing polarity, connect the driver wires

from the input panel.

9. Replace the rear panel.

10. Perform the test procedures in this service manual to ensure proper operation before return-

ing the unit to the customer.