Atlas Copco PHE 3X Repair Instruction - Page 13
Browse online or download pdf Repair Instruction for Drill Atlas Copco PHE 3X. Atlas Copco PHE 3X 14 pages.
Print PageAssembling the
1 Mount the disk springs (1) with the
spindle
bulgings head-on (see Illustration).
(mounting the
2 Mount the clutch (the ratchet (2) with
outer parts)
indentations against the toothing of the
spindle wheel (3)).
3 Fit the locking ring (4) and press it on
against the pressure of the disk springs.
4 Mount the locking slide (5) and the
retaining clip (6).
5 Mounting the rear thrust bearing (7):
- profile ring with damper-O-ring
- two compensating washers
- thrust bearing
- washer
6 Secure the rear thrust bearing (7) with the
special locking ring (8).
Mounting the
1 Fit the spindle (2) to the motor housing (4)
spindle
and fasten it with two screws (1) (6 Nm,
additionally secure it with screw locking
device).
2 Push the ring gear (7) over the back gear
shaft (8) and let it engage in the locking
slide (3).
3 Push the planetary gear (6) onto the back
gear shaft and fit them into the ring gear
(7).
4 Push the straight pin (5) through the
locking slide (3) and insert it into the
motor housing (4).
Mounting the
1 Insert the sleeve (1) (service tool No.
gear housing
4931 5990 38) into the gear housing (2)
(the sleeve protects the rotary shaft seal
in the gear housing from damage during
assembly).
2 Fit the gasket (3) to the motor housing (4).
3 Fasten the gear housing (2) to the motor
housing (4) and fix it with screws (2,5+5
Nm).
4 Fit the switch lever (5) (mount it in the
"hammer" position, the pin must grasp the
elongated hole of the locking slide).
Repair Instruction No. 175.8/95
1
1
2
6
5
PHE 3, PHE 3X
2
3 4
7
8
5
6
3
4
7
8
1
2
3
4
5
PAGE
13
12
1 3
14