Bose 901 Owner's Manual - Page 8

Browse online or download pdf Owner's Manual for Speaker System Bose 901. Bose 901 20 pages. Vi direct/reflecting speaker system
Also for Bose 901: Owner's Manual (41 pages), Owner's Manual (23 pages), Assembly And Mounting Instructions (1 pages), Owner's Manual (12 pages), Installating And Operation Manual (15 pages)

Bose 901 Owner's Manual
8
With your speakers in their chosen locations, connect them to the receiver.
It is important to use the right thickness of speaker wire. For distances of up to 30 feet (9 m),
2
18 gauge (.075 mm
) 2-conductor wire works well. For distances greater than 30 feet (9 m),
refer to the wire recommendations chart on page 18.
Note: To determine if this wire is suitable for use in a wall or under a floor, check your local build-
ing codes. You may want to contact a qualified electrical installer for this information.
Examine the speaker wire. Note that it is actually a pair of insulated wires that may be gently
pulled apart. The insulation around one wire is marked with a stripe, collar, rib, groove, or
printing. Use the marked wire as positive (+) and the unmarked wire as negative (-). These
wires correspond to the positive and negative terminals on the speaker and receiver.
It may be difficult to distinguish wire markings. Inspect both wires carefully.
To prepare the ends of each wire:
1
1. Strip approximately
/
2. Twist the bare ends of each stranded wire, to prevent strands from touching across
terminals.
Before making any connections, turn off your receiver and unplug it from the AC
(mains) power outlet. Not doing this may result in damage to your system.
Speaker terminals are located on the bottom of each speaker. Unscrew the knurled nut on
each terminal and remove one washer. Wrap one bare wire end around the terminal post.
Then, replace the metal washer on the screw post and screw the knurled nut firmly back on.
1. Connect one wire pair to the right speaker (the one on your right as you face it).
a. Attach the marked wire at one end to the positive (+) terminal.
b. Attach the plain wire at that end to the negative (-) terminal.
2. Connect the other ends of the same wire pair to the RIGHT SPEAKER OUTPUT of your
receiver.
a. Attach the marked wire to the positive (+) terminal.
b. Attach the plain wire to the negative (-) terminal.
3. Following the steps above, connect the second pair of wires to the left speaker and to the
LEFT SPEAKER OUTPUT on the receiver.
If your receiver offers a choice of output impedances, use the terminal marked 8 or 8
ohms.
inch (12 mm) of insulation from both wires.
2