Bose Acoustimass 6 Series II Owner's Manual - Page 11
Browse online or download pdf Owner's Manual for Speaker System Bose Acoustimass 6 Series II. Bose Acoustimass 6 Series II 23 pages. Bose acoustimass 6 series ii: owners guide
Also for Bose Acoustimass 6 Series II: Owner's Manual (33 pages), Owner's Manual (28 pages)
Print Page
Figure 9
Speaker cable connections to
the cube speaker
AM252172_02_V.pdf
Setting Up Your Acoustimass
Connecting the Acoustimass
cube speakers
CAUTION: Never connect the cubes directly to the receiver. Always connect the cube
speakers to the Acoustimass module, then connect the Acoustimass module to the receiver.
Use the 20 foot (6 m) cable with three pairs of wires to connect the Acoustimass module to
the center and front cube speakers. Refer to Figure 8.
1. Connect the wire pair marked CENTER to the cube speaker you have placed in the center
position. Press the terminal tab on the back of the speaker (Figure 9). Then insert the
marked wire (+) into the red terminal and the plain wire (–) into the black terminal. Release
the tab to secure the wires in place.
2. In the same way as in step 1, connect the wire pair marked RIGHT to the cube speaker
you have placed in the right front position (to the right of the TV as you face it).
3. In the same way as in step 1, connect the wire pair marked LEFT to the cube speaker you
have placed in the left front position (to the left of the TV as you face it).
At the Acoustimass module, check to be sure the connectors are firmly inserted into the
proper OUTPUTS TO CUBE SPEAKERS jacks.
• The black L connector goes into the L jack.
• The gray C connector goes into the C jack.
• The black R connector goes into the R jack.
Connecting the Acoustimass module to the surround cube
speakers
Use the 50 foot (15 m) cable with two pairs of wires to connect the right and left surround
cube speakers to the Acoustimass module. Refer to Figure 8.
1. Connect the wire pair marked RIGHT SURROUND to the right surround cube speaker (on
your right as you face the TV). Press the terminal tab on the back of the speaker (Figure 9).
Then insert the marked wire (+) into the red terminal and the plain wire (–) into the black
terminal. Release the tab to secure the wires in place.
2. In the same way as in step 1, connect the wire pair marked LEFT SURROUND to the left
surround cube speaker (on your left as you face the TV).
At the Acoustimass module, make sure the gray connectors are firmly inserted into the LS
and RS OUTPUTS TO CUBE SPEAKERS jacks.
October 29, 2001
®
6 Speaker System
®
module to the center and front
11