Bose PANARAY MB4 Service Manual - Page 7
Browse online or download pdf Service Manual for Speaker System Bose PANARAY MB4. Bose PANARAY MB4 11 pages. Modular bass loudspeaker
Also for Bose PANARAY MB4: User Manual (2 pages), Installation Manual (16 pages)
Print Page
Audio
Audio Signa
1. Air Leak Test
1.1 Set up the system for test as shown in
Figure 3.
1.2 Apply a 100 Hz, 10 Vrms sine wave to
the input connectors.
1.3 Listen carefully for any air leaks from
around the end cap, drivers and the baffle.
Air leaks will be heard as a hissing or sput-
tering sound. All repairs must be hidden.
Test duration should be 5 seconds minimum.
2. Rub and Tick Test
2.1 Perform disassembly procedure 3. It is
not necessary to unplug the wires at the
driver assembly terminals.
2.2 Connect a signal generator directly to
the terminals of the driver under test.
2.3 Apply a 10 Hz, 10 Vrms sine wave to the
driver assembly.
2.4 Listen carefully for any extraneous
noises, such as rubbing, scraping or ticking.
Note: To distinguish between normal sus-
pension noise and rubs or ticks, displace the
cone slightly with your fingers.
Test Procedures
Signal
Generator
Generato
Powe
ower Am
Ampli plifie ier
INPUT
INPU
Figure 3. Panaray
OUTPUT
OUTPU
®
MB4 Test Setup Diagram
If the noise stays the same, it is normal
suspension noise and the driver is fine.
Suspension noise will not be heard with
program material.
3. Phase Test
3.1 Apply 10 VDC to the loudspeaker input
connector. Apply the positive to pin "1+" and
the negative to pin "1-" of the Neutrik
connector.
3.2 When applying the DC voltage level,
observe the driver cones. They should all
move outward when the DC level is applied.
3.3 Rewire any incorrectly wired driver.
4. System Sweep Test
4.1 Set up the system for test as shown in
Figure 3.
4.2 Apply a 10 Hz, 10 Vrms sine wave to the
loudspeaker input connector.
4.3 While listening to the output of the
system, sweep the input frequency slowly
from 10 Hz to 400 Hz.
4.4 Listen carefully for any extraneous
noises such as buzzing or ticking.
7
®