ABSCO SHEDS SIGNATURE ADGAZEBO33 Instruction Manual - Page 10

Browse online or download pdf Instruction Manual for Outdoor Furnishing ABSCO SHEDS SIGNATURE ADGAZEBO33. ABSCO SHEDS SIGNATURE ADGAZEBO33 14 pages.

Print Page
SIDE FLASHING - FASTENING
REAR LEFT UNDERSIDE
VIEW
6. Repeat these steps for
the other side flashing. Just
remember
mirrored version.

FRONT EDGE

FRONT FLASHING
FRONT UNDERSIDE VIEW
Absco Industries
Assembly Instruction Manual
ABSCO SIGNATURE GAZEBO
MODEL: ADGAZEBO33
3.11m W x 3.11m D x 2.60m H
to
make
FRONT LEFT TOP VIEW
5. Refit the flashing, and fasten using pop rivets
FAST102 at the locations shown.
Only at the rear, on top, use teks with neoprene
washers FAST101.
the
To increase weather protection at the front do the
following.
A. Turn up pans of sheet 15 degrees using "Sheet
Metal Locking Pliers"
B. Installing foam gaskets RWG28 within 90mm
of the front edge.
Some trimming may be required to fit at ends.
Apply silicone to the face that sits in the pan.
1. At the front, take an outside measurement from
the left to the right flashing.
Trim the front flashing TR37 to this length.
2. Cover the front edge of the roof and flashings.
Carefully lift over gaskets.
3. Fasten with pop rivets FAST102 along the
underside are shown.
Fasten with tek screws with neoprene washers
FAST101 along the top.
Model: ADGAZEBO33
FRONT LEFT UNDERSIDE VIEW
21/09/23
1.00
10