Operating Your Wave
Setting the alarms
Note: You can set alarms with the Wave
Function
To enter alarm setup mode - Press and release Alarm Setup. The system is now in alarm
setup mode. ALARM 1 flashes for 10 seconds.
To select which alarm to set - While ALARM 1 is flashing, set alarm time, volume, and alarm
sound (tone
, radio, or CD), for Alarm 1. Press Alarm Setup again until ALARM 2 is flashing.
While it flashes for 10 seconds, begin to set Alarm 2.
To set the alarm time - While the selected alarm is flashing, press the Time
alarm time. The selected alarm flashes for 10 seconds.
To set the alarm source - While the selected alarm is flashing, press FM, AM, or CD Play
to select and display that source. The tone
• To reset to tone
, press the source currently selected (FM, AM, or CD Play
deselects it.
• When no source is displayed, the alarm is set to tone
• Setting FM or AM alarm, the station last used for this alarm is shown. Or, use Presets or
Track⁄Tune
or
to select a station.
• Setting CD alarm, track 1 is shown. Or, use Track⁄Tune
location for the alarm. Press CD Mode
plays, repeating as needed, until the alarm shuts off.
• To set radio or CD followed by tone
AUX is not available as an alarm source.
To set the alarm volume - While the selected alarm is flashing, press Volume L or M to set
the alarm volume, from 10 to 99. The selected alarm flashes for 10 seconds.
To test the alarm volume - While the selected alarm is flashing, hold down Alarm Setup and
press Volume L or M to hear the volume setting, as demonstrated by the tone
To adjust snooze time - The system is set for a standard 10-minute snooze time (the number
of minutes you can delay the alarm). While the selected alarm is flashing, hold down Sleep⁄Snooze
and press the Time
or
number of minutes and Sn appear on the display to confirm your selected snooze time. You can
set a different snooze time for each alarm.
To exit from alarm setup - To leave alarm setup mode, wait 10 seconds for it to disengage.
Or you can press AUX once or Alarm Setup a few times until there is no ALARM 1 or ALARM 2
flashing.
To check the alarm setting - To display the alarm setting for 10 seconds, press and release
Alarm Setup. Press again to display one alarm setup and repeat to display the other alarm setup.
Reading the alarm setup displays
Figure 13
Examples of alarm setup
displays
20
®
radio/CD
®
radio/CD on or off.
is no longer selected.
to select RANDOM or TRACK REPEAT. The CD
, select radio or CD alarm, then press
to adjust the snooze time (from 1 to 30 minutes) for that alarm. The
1
Alarm
Setup
ALARM 1 flashes. You can begin by setting the time.
2
FM
Pressing FM selects it as the source for ALARM 1.
or
), which
.
or
to select a specific track or time
CD Stop I.
alarm only.
3
Alarm
Setup
4
CD Play
Time
Time
Alarm 1
Alarm
On/Off
Setup
Presets
1
2
4
5
Track/Tune
CD Play
CD Stop
FM
AM
Stop
Alarm
Control panel
Sleep/Snooze
On/Off
Wave Radio/CD
Alarm
Setup
Alarm
Setup
to set the
Time
FM
AM
Track/Tune
CD Mode
CD Stop
Alarm
Setup
Sleep/Snooze
Time
AUX
Alarm
Setup
ALARM 2 flashes. You can begin by setting the time.
Pressing CD selects it as the source for ALARM 2.
Alarm 2
On/Off
3
6
CD Mode
AUX
Volume
Time
CD Play
Time
Alarm
Setup
Print Page