Bose Lifestyle 35 Series II Owner's Manual - Page 9

Browse online or download pdf Owner's Manual for Headsets Bose Lifestyle 35 Series II. Bose Lifestyle 35 Series II 25 pages. Noise cancelling
Also for Bose Lifestyle 35 Series II: Installation Manual (42 pages), Installation Manual (36 pages), Owner's Manual (24 pages), Owner's Manual (13 pages), Quick Setup Manual (3 pages), Operating Manual (46 pages), Owner's Manual (36 pages), Owner's Manual (32 pages), Quick Start Manual (2 pages), Factory Reset (2 pages), Quick Start Manual (2 pages), Owner's Manual (38 pages)

Print Page
Bose Lifestyle 35 Series II Owner's Manual
S
ETUP
Figure 6
Connections using the
adapter cable

Check the indicators and settings

8
Source Product
Audio Output
L
R
Transmitter
Adapter cable
3. Complete the connections using the power pack:
–
Insert the small plug on the power pack cable into the AC Power jack.
–
Plug the pack into an AC wall outlet.
The Status LED lights to verify this power connection.
Note: For information on the meaning of the different Status LED lights, refer to "Check the
indicators and settings" below.
To control volume when a non-Bose product is the sound source:
• There is no need for an expansion room remote control.
• Use the remote that came with the tuner/receiver in the room where it is connected to the
transmitter.
• Use the volume control on the system, radio, or powered speakers connected to the
receiver in the other room.
To control non-Bose or older Bose products in the expansion room:
®
• Use a Bose
link remote control or the PERSONAL
®
LIFESTYLE
system in the main room.
• Use the product remote or console control for local volume adjustments.
Before you use the audio link, you may want to check some of the indicators and settings
that make your expansion products work together smoothly.

The Status LED

On the connection panel of both the transmitter and the receiver, the Status LED indicates
how the two units are communicating, as shown in the table below.
Status LED
Blinking Green
Searching for
On the
receiver
transmitter
Searching for
On the
transmitter
receiver
On the receiver, a blinking or solid orange light indicates a communications problem. Reposi-
tioning the transmitter or receiver, or both, may resolve the problem and cause both LEDs to
change to solid green. For further information, refer to "Troubleshooting" on page 10.
Français
Expansion Room Product
Audio Input
L
R
Receiver
®
Bose
link
INPUT
®
music center II to select audio from the
Solid Green
Blinking Orange
Receiver
Not
located
applicable
Solid signal
Weak signal
received
received
Español
English
Bose
OUTPUT
Adapter cable
Solid Orange
Powered on,
no communication
Weak or no signal
received
®
link