Bose X Owner's Manual - Page 17

Browse online or download pdf Owner's Manual for Headsets Bose X. Bose X 36 pages. Installation of headset into cloth/leather helmet
Also for Bose X: Installation (4 pages)

Print Page

ETTING

OUR

EADSET

EADY FOR

Notes

For use with a stereo intercom, connect the left and right channels to

their respective positions. For monaural operation, connect pins 3 &

4 together to the tip of the existing phone jack.

Do not use excessive force or bend the installed connector. This may

damage or break internal solder joints.

If the boom microphone works on radio transmit but not through the

intercom, check pin 6. It may be incorrectly wired to the PTT seg-

ment of the microphone jack.

The wires connecting pins 3 & 4 and pins 5 & 6 are shielded, twisted

pairs with a black wire shield termination exiting each pair. If existing

wiring is not shielded, connect shields to existing audio wiring

shields, or connect shield from Comm L and Comm R wire pair to

audio ground.

The Bose

aircraft panel connector cannot be installed to an audio

system using transformer-coupled audio outputs. Call the Bose Avia-

tion Headset Department for details.

Use proper adhesives

Adhesives approved for use with this connector are:

• Ciba-Geigy Uralane 5754-A/B

• Lord 710

• VTCS-6 Vibratite

Do not let cyanoacrylate-based adhesives, flux remover, or other

caustic compounds contact the connector body. These chemicals

cause irreparable damage to the connector. For information on

chemical compatibility and connector part number, call LEMO

USA,

Santa Rosa, CA at 1-800-444-5366.