Bose XLR5 Owner's Manual - Page 10

Browse online or download pdf Owner's Manual for Headsets Bose XLR5. Bose XLR5 44 pages. Aviation headset

Print Page

Preparing the Headset for Use

Your headset may be shipped with the microphone assembly (boom microphone

and cable) attached to the left earcup. If you prefer, you can switch it to the right

earcup.

If your headset is shipped with the microphone assembly packed separately, you

can attach it to either earcup.

Choose the earcup (L or R) where you want to attach the microphone assembly.

Also, make sure that the earcup connector pins are clean and free of debris.

Use a Phillips screwdriver to loosen the two screws on the terminator cover

near the bottom of the earcup where you want to attach the microphone

assembly.

Remove the terminator cover to reveal the connector pins on the earcup.

Carefully line up the microphone assembly to the small connector socket on

the earcup.

Slide the connector into the socket until it reaches the stop.

Terminator

cover

Caution: Do not force the connector into the socket, or earcup damage may

occur.

Tighten the screws to secure the assembly.

Attach the terminator cover to the earcup that does not have the microphone

assembly attached. Insert the screws, then align and tighten them.

Note: The headset will not work without the terminator cover installed.

Caution: Be sure to try the headset and fully test its operation before flight.

10 - English

Connector

pins

Microphone

assembly

Connector pins

L (left)