anko LD-K1045 User Manual - Page 6
Browse online or download pdf User Manual for Kettle anko LD-K1045. anko LD-K1045 7 pages. Cordless water kettle
Print Page
IMPORTANT! This appliance is not intended to heat liquid other than water
1. Press the lid release trigger. The lid will open automatically.
2. Fill the kettle with the amount of water required. You can check the water fill level on the water indicator
on the kettle.
3. Press the lid front location down firmly to close it.
Make sure that the lid is tightly closed during use.
Otherwise, the water kettle may not switch OFF after boiling
4. Fully unwind the power cord and run it through the cable guide channel on the base.
5. Plug the mains cable into an earthed socket that is within easy reach.
6. Place the kettle on the base and press the 100℃ (boil) button on the base.
The control blue lamp will blink to indicate that the kettle is ON.
When the kettle has finished boiling, the kettle switches off automatically and the control blue lamp will
remain ON and switch OFF after 5 minutes.
7. If you wish to stop heating the water before it boils, press the selected temperature button again to switch
off the kettle.
* Be sure that the water kettle is switched OFF before removing it off the power base.
8. After the water has come to a boil, wait a moment, until the water has stopped simmering.
Remove the kettle from the water base.
CAUTION! Risk of burns from boiling water.
9. Pour the water out slowly to avoid splashing. Do not open the lid while pouring out the water.
* The sieve insert in the spout prevents any larger particles of scale being poured out.
* Do not re-boil stale water. Pour it away.
DANGER– risk of fatal electric shock
* Remove the mains plug from the wall socket before cleaning the kettle.
* The power base, plug and mains cord must not come into contact with water or other liquids.
* The kettle must not be immersed in water or liquid.
* The product and its parts must not be cleaned in the dishwasher.
CAUTION- material damage
* Do not use caustic, aggressive or abrasive cleaning products for cleaning.
* Do not use alkaline cleaning agents while cleaning, use a soft cloth and mild detergent.
Cleaning
1. Remove the supply cord plug from mains power socket and let the water kettle cool down completely.
2. Wipe off the base and power cord with a dry cloth.
3. Wipe the outside of the jug with a slightly moistened cloth.
4. Pull the sieve out of the spout and off for cleaning if necessary.
5. Rinse it off under running hot water.
Decalcification
IMPORTANT! during the below process DO NOT fill the kettle more than the MIN. (0.5L) mark on the
kettle.
Filling above the min. mark will cause over boil and spillage out of the spout.
The kettle must be descaled at regular intervals, especially if the power base is visibly encrusted with lime
scale. Regular descaling saves energy and increases the service life of the kettle.
For ecological reasons, we recommend using a three-to-one solution of water and vinegar or water and citric
acid to descale the kettle.
• Fill the kettle with water and add vinegar in a ratio of 1:3 (1 part vinegar / 3 parts water).
Note: Make the mixture in a separate container and then pour into the kettle, not more than the MIN.
(0.5L) mark.
• Let the solution soak in the kettle for about an hour and then bring it to the boil.
•
Thoroughly rinse out the kettle with fresh water.