Beckmann Egle MT 20x2 Manual - Page 5

Browse online or download pdf Manual for Control Unit Beckmann Egle MT 20x2. Beckmann Egle MT 20x2 20 pages.

Print Page
MT 20x2/40x2

Set-up

Assembling the display on the MiniTerminal is easy with the assembly materials provided.
This is illustrated below with a 20x2 display. The procedure is the same for other types
although the position of the plug may vary from the illustration.
A
Assembly
1.
You will need
•
•
•
•
•
•
•
•
•
2.
Soldering in the connectors
•
•
•
•
3.
Assembling
•
•
Copyright BECKMANN+EGLE GmbH, all rights reserved.
MiniTerminal
Accessory pack (included with
MiniTerminal)
Layout diagram
20x2 Display
Soldering iron and solder
Screwdriver
Power supply, 5V stabilised
Interface cable
PC with TerminalProgramm, e.g.
HyperTerminal or MITAS
software, available separately
Solder socket board to display.
Do NOT solder directly to
MiniTerminal !
Depending on the display in use,
solder the pin connectors to the
matching soldiering position on
the reverse of the PCB
the pin connectors fit precisely
when both circuit boards are
assembled back to back
does not need a connecting cable
Depending on the display type
being used, some of the
mounting holes cannot be used.
In order to avoid short-circuits
between display ans Terminal put
a suited placeholder between.
Mount the display with the help of
the spacers, screws and washers
provided (affix these on the
terminal side to avoid short-
circuits on the MiniTerminal).
MiniTerminal standard accessories
Readily assembled module
Page 5
Pins here
Bushings
Internet: www.bue.de