Ankom Daisy D200I Replacement

Browse online or download pdf Replacement for Accessories Ankom Daisy D200I. Ankom Daisy D200I 4 pages. Motor replacement

Print Page

To replace the Motor on the ANKOM Daisy

Note: The following items will be sent in a replacement package: New Motor (120v or 220v), fan for the 120v motor.

Prepare the instrument for service.

a. Power off the instrument.

b. Remove the back panel of the Daisy cabinet using a Phillips

screwdriver. Set aside the four screws for later use.

220v Motor: Disconnect the two motor wires from the Terminal

Block Assembly.

*Refer to the labeled image (right) of a Terminal Block Assembly

for the following steps in this procedure.

a. Insert a small flat-blade screwdriver into the correct terminal

blocks to unscrew the screw inside the circular holes and

loosen the wires.

b. Unscrew the white wire from the #1 gray terminal block and

the red wire from the #3 blue terminal block.

Note: Refer to the manual for further wiring instructions.

120v Motor: Disconnect the four motor wires from the Terminal

Block Assembly.

a. Insert a small flat-blade screwdriver into the correct terminal

blocks to unscrew the screw inside the circular holes and

loosen the wires.

b. Unscrew the blue and white wires from the #1 gray terminal

block and the brown & black wires from the #3 blue terminal.

Note: Refer to the manual for further wiring instructions.

ANKOM Technology  2052 O'Neil Road  Email: [email protected]  Phone: 315-986-8090  Fax: 315-986-8091

Motor Replacement

D200/D200I

Incubator, follow the steps below.

Service Procedure

Revised: 08/06/2014

Terminal Block Assembly

Blocks 1-6

Terminal #1

Terminal #3

Terminal #1

Terminal #3

001

5 6

pg. 1 of 4