ABSINA 34-116-1002 Operating Manual - Page 14

Browse online or download pdf Operating Manual for Battery Charger ABSINA 34-116-1002. ABSINA 34-116-1002 20 pages.

Print Page

8. WALL HOLDING

The wallbox may only be screwed to walls with an

appropriately firm base. Pay attention to cables that

may run in the wall.

1. Mark 2 drill holes in a suitable place using the wall

bracket.

2. Drill two 6mm holes and insert the enclosed dowels.

3. Screw the wall bracket to the wall using 2 of the

4x40mm screws provided.

4. Then screw the securing plate to the wallbox using 2

M3x10 metric screws.

5. Then hang the wallbox on the wall bracket and mark

the drill hole for screwing the securing plate to the

wall.

6. Remove the wallbox from the bracket, drill a 6mm

hole at the marked location and insert the enclosed

dowel.

7. Now you can hang the wallbox on the wall bracket

and screw the securing plate with the 4x40mm

screw.

Securing plate

Wall bracket

Deutsch . English

9. OPERATING ELEMENTS

10. LCD DISPLAY

7. Temperature display (internal temperature)

8. Display supply voltage in V

9. Current charging capacity in kW

10.Charging time

11. Current charging current in amperes (only for 3-

phase charging)

12.Charged energy in kWh (only with 3-phase

charging). This value is not saved after the loading

process is finished.

13.Set charging current in amperes (Note: The charging

current is regulated by the OBC in the car and may

therefore be below the set maximum value à for

actual charging see point 11)

14.Time preselection charging start

1. Charging indicator

2. Emergency stop switch

3. LCD display

4. Sensor button for

charging current setting

5. Sensor key for start

preselection

6. RFID receiver