Becos TS8-MS Overdrive Midi Switching Quick Setup

Browse online or download pdf Quick Setup for Switch Becos TS8-MS Overdrive Midi Switching. Becos TS8-MS Overdrive Midi Switching 4 pages. Analog overdrive with external relay switching and midi functions
Also for Becos TS8-MS Overdrive Midi Switching: Quick Start Manual (6 pages)

Print Page

TS8-MS Quick Setup

For full product information go to

1. Power off pedal (battery or DC power adapter) and set the Multi Function rotary HEX

switch inside to a position corresponding to the desired setup setting.

2. Push and hold the Footswitch while power on pedal and continue to hold the Footswitch

for at least 3 seconds, until visual indication of LED's confirm saving the setting.

3. Power off pedal. The setting is saved. Power on pedal and start using it.

Set the type of Bypass

Bypass Type

Buffered Bypass

HEX = A

(factory default)

Relay True Bypass

HEX = B

Set the switching mode of External Switching Relays

Switching Type

Latching Switching

HEX = 0

(factory default)

Momentary

HEX = 1

Switching

Reset to Factory Defaults

Reset

Factory Defaults

HEX = F

* After setting procedure is finished (power off), you may need to set the Multi Function switch to a different in operation position than

the one used for setup.

** During setup, LED blinking is continuous until power off. Steady lit LED's remain as such until power off.

http://midi-overdrive-switcher.becosfx.com/

Multi Function

Visual

Switch Position*

Indication**

Multi Function

Switch Position*

Indication**

Multi Function

Switch Position*

Indication**

http://midi-overdrive-switcher.becosfx.com/

Silent "soft switching" using FET transistors

placed between input and output buffers. No

sound loss even with long connection cables.

Recommended and used as factory default.

Mechanical switching using relays controlled

by a microcontroller. In bypass or without

power, signal goes directly from input to

output. Avoid long connection cables.

Visual

External Relay switching with latching. When

relays are ON, Tip-to-Ground or/and Ring-to-

Ground are shorted and mentained until OFF

command is initiated.

External Relay switching is momentary ON.

Tip-to-Ground or/and Ring-to-Ground in the

External Switching 1/4TRS Connector are

shorted momentarely (100ms ON, then OFF)

for either "ON" or "OFF" relay commands.

Visual

Pedal settings are restored to factory defaults.

Download Full Manual

Notes