Drucker Diagnostics DASH Flex Series Operator's Manual - Page 9
Browse online or download pdf Operator's Manual for Laboratory Equipment Drucker Diagnostics DASH Flex Series. Drucker Diagnostics DASH Flex Series 18 pages.
Print Page
F
M
REE
ODE
Change time, RPM or g-force for a single cycle.
Setting by G-Force
C
N
C
REATE
EW
YCLE
Change Settings
D
C
C
ISPLAY
YCLE
OUNT
Display Cycle Count
Drucker Diagnostics – Customer Service: +1-814-692-7661 – [email protected] | Page 5
To change the speed (RPM) shown on the top display, use the up
and down buttons next to that screen. The CYCLE number is
Setting Speed
replaced with a "--"in the display, and the top screen displays the
speed.
Press and hold the RCF (xg) button while changing the displayed
setting on the top screen, using the up and down buttons next to it.
The RPM will automatically adjust.
Setting Time
Press the up and down buttons next to the TIME display.
Access the menu.
Press the down key next to the top screen until it shows "Brake".
Change Brake
To turn brake on and off, use the up and down buttons next to the
Values
TIME display.
Exit the menu.
Access the menu.
Press the up and down keys next to the upper screen until
Turn Beeper
"Beeper" shows on the upper screen. Switch ON or OFF with the
On or Off
keys next to the lower screen. This setting will apply to all cycles.
Exit the menu.
Refer to previous table (Free Mode) to change speed and time to
desired values.
Save Cycle
Hold the CYCLE button until you hear a double beep.
With the lid open and the unit powered, press and hold the START
button. The cycle count will be displayed until the START button is
released.