DrumCraft Series 4 Assembly Instructions - Page 3

Browse online or download pdf Assembly Instructions for Drums DrumCraft Series 4. DrumCraft Series 4 4 pages.

Print Page

Claw

Bearing

Edge

Bass

Drum

Mount

Fold the Spur forward

Tom

Holder

Bass Drum

Mount

Knurled

Nut

Bottom

Section

1. Place the bass drum (T) on the floor, so the bearing edge points

towards the top.

Hoop

2. Place the white BD head (B) on the bearing edge, and center the logo

Head

so you can read it.

3. Center one of the BD hoops (D) onto the aluminium ring of the head.

4. Slide the one nylon washer (H) on each BD tension rod (E).

Spur

5. Slide the tension rod including washer into the BD claw hooks (F).

6. Position every tension rod, washer claw hook unit onto the hoop and

screw the tension rod into the receiver nut of the lugs. Tighten the

tension rod by hand only. Tuning will be done later.

7. Turn the shell upside down.

Lug

8. Repeat step 1– 6 on the batter side of the drum with the clear head.

9. Set the shell right side up.

10. Loosen the spur's wing nut and angle the spur forward to the deter

mined slots and fix it again.

11. Extend the spur by loosen the square head screw with the drum key.

Fix the legs so the front end of the BD is lifted about 3 cm (two fingers

wide) off the ground.

Tom

12. Insert the single post (O) into the bass drum mount of the bass drum.

Bracket

13. Insert the tom holders (P) into the matching holes of the single post.

14. Loosen the wing screw of the tom bracket of the rack tom (Q, R) to

slide onto the tube of the tom holder. The nose of the memory lock

Single

should snap in the notch of the bracket.

Post

15. Tighten the wing screw of the bracket.

16. Set the angle and height of the toms that an imagined line of the batter

head points towards your hip.

Hoop

Head

17. Separate the hoops from the floor tom (S) by loosening the two tension

rods.

Lug

18. Place one head on the bearing edge of the tom. Center the hoop on the

head and slide the tension rods with washers through the holes of the

hoop into the receiver nuts of the lugs and tighten them.

FT Bracket

19. Repeat this step for the opposite side.

20. Position the floor tom legs in the brackets and tighten the wing screws.

FT Leg

21. Set the height of the tom as an imagined line from the batter head

points towards your hip.

22. Spread the legs on the bottom section of the Snare Stand (J) and

tighten the wing screw. Slide the tube of the top section into the base

section and tighten the wing screw on the tube joint.

Basket

23. Tip the basket of the stand to an upright position and spread it open

by hand, if it doesn't open as wide as you need for the snare, use the

knurled nut to fine adjust the width.

24. Place the Snare onto the basket and tighten the knob so the three arms

embrace the snare drum with no tension.

bd A

ssembly

bd s

etuP

Ack

oms

loor

ssembly

nArestAnd