Anntlent AN-CPL70A Plus User Manual - Page 8

Browse online or download pdf User Manual for Extender Anntlent AN-CPL70A Plus. Anntlent AN-CPL70A Plus 12 pages. Cell phone signal booster

Print Page
other barriers can be used in between to increase isolation.
Fix the donor antenna after selecting the best position, and adjust slightly its height
or angles in order to get the signals with suitable input power level and calling
quality.
（2）Installation of Indoor Antenna
Proper antennas shall be selected according to the site conditions and the
requirement.
Omni antenna (Indoor ceiling omni antenna or whip antenna), is suitable to be
installed in the center and radiate all directions.
Indoor antenna must be operated at a fixed location inside a building, it is better to
use a directional panel antenna when the coverage building is long and narrow.
Connect the indoor antenna to the booster connector marked INDOOR with 20 FEET
3D-FB Coaxial cable with N male connector
Notes：
Booster transmitting in 1710-1755 MHz should be install/operate in one of two ways:
(i) the antenna for the device must be installed to comply with the 10 meter above
ground maximum antenna height limitation OR
(ii) the antenna for the device has a 10 meter above ground maximum antenna height
limitation when the device is used with a handset that covers the 1710-1755 MHz band and
that owners could be subject to potential FCC enforcement action for noncompliance.
（3）Booster Installation
Do not place the equipment in direct sunlight or in an area that has abrupt
temperature and humidity changes .
it is suggested that the booster is installed in a cool，dry and ventilated room without
erosive gas and smoke.
Connect power adaptor to the booster， connect The other end of power adaptor to the
power outlet.
WARNING:
The input voltage for the booster is 5~12V DC.
power supply that NOT 5~12V DC . otherwise, it will be damaged and the user may also
be injured.

TROUBLESHOOTING AND SUPPORT

DO NOT use this Booster with a regular
8 / 12