Anolis ArcSource Wall 3 Instructions For Use
Browse online or download pdf Instructions For Use for Outdoor Light Anolis ArcSource Wall 3. Anolis ArcSource Wall 3 3 pages.
Print PageThe products generate colored light by means of high power LEDs.The products were designed for exterior
use and they are ideal for locations where signaling,directional or effect lighting is required.
1.Attention:
Consider the respective national norms during the installation!
Do not install the unit near naked flames.
Avoid using the unit in locations subject to possible impacts.
Do not attempt to dismantle or modify the unit.
Do not install the module in badly ventilated location
Avoid looking directly into the LED light beam at close range.
2.Installation:
The ArcSource Wall unit should be connected to the ArcPower driver according to the LED colour variant
(RGB,WW,CW...).
See ArcPower 36 ,ArcPower 44 ( or ArcPower SmartWhite 36,ArcPower SmartWhite 44) user manual for
full details of mains power requirements and DMX operation.
The ArcSource Wall unit can be arranged in any position orientation.Body of stainless steel tube is mounted
on 75mm diameter mounting base.
Connect the ArcSource Wall to the driver via an adapter cable Chogori/RJ45 and use suitable cable joint box
(weather-tight for outdoor installation) if the cable has to be extended.The Belden cable and Chogori connector
has the following wiring:
Adapter cable Chogori/ RJ45 betwen fixture and LED driver
User instructions
ArcSource Wall 3, ArcSource Twin Wall 3