Foursevens Quark Turbo QB2L-X Operator's Manual - Page 3
Browse online or download pdf Operator's Manual for Flashlight Foursevens Quark Turbo QB2L-X. Foursevens Quark Turbo QB2L-X 3 pages.
Print Page
QB2L-X
OPERATOR'S MANUAL
Specifications
Dimensions
Power Source
Length:
5.2 in
Two CR123A or Two RCR123A Batteries
Diameter:
1.52 in
Operating Range: 3.0~8.4 V
Weight: 4.7 oz
Typical Output and Runtimes
Output (out the front)
Mode
Runtime
Moonlight
0.3 lumen
20 days
2.6 days
Low
8 lumens
Medium
60 lumens
13 hours
High
260 lumens
3 hours
Max
450 lumens
1.5 hours
Strobe
3 hours
S.O.S.
6 hours
Beacon
15 hours
* Beacon mode first flashes 5 times, then once every 10 seconds.
Model
QB2L-X
POWER
Two CR123A batteries
Maximum: 450 lumens
OUTPUT
Moonlight: 0.3 lumen
Maximum: 1.5 hours
RUNTIME
Moonlight: 20 days
SOS
Strobe, S.O.S and Beacon
STROBE
flash modes
Warranty
FOURSEVENS warrants its products to be free from defects in materials and
workmanship. We will repair or replace, at our option, without charge any product or
part which is found to be defective under normal use and service within 120 months
from the date of purchase with proof of purchase. Such repair or replacement shall
be the purchaser's sole and exclusive remedy under this warranty. This warranty
does not cover normal maintenance and service and does not apply to any products
or parts which have been subject to modification, misuse, abuse, negligence,
accident, or improper maintenance or repair by anyone other than
FOURSEVENS
4Sevens, LLC
5117 S Royal Atlanta Drive
Tucker, GA 30084
678.608.0308
www.
foursevens
.com
Operation
Operating your Quark Turbo QB2L-X is simple. Insert its batteries with the
positive side (+) toward the head. Make sure the head and tailcap are
tightened, then depress the tailcap button fully so that it 'clicks' and the light
turns on. You can also press the tailcap lightly (you don't have to 'click' it on)
to activate the light momentarily.
Your Quark TurboX can memorize any two modes of output, from its eight
total modes, to be instantly available. These two modes are accessed by
either tightening or loosening the head (for example, tight can be Max, and
loose can be Low).
To have your Quark TurboX memorize a different mode, turn it on and
loosen the head by a half-turn. Then, tighten the head at least four times
rapidly (twist it tight, then loose, then tight, etc., four times). After the fourth
time, leave the head tight or loose, depending which position want to program.
After three seconds, the light will flash. It is now ready to be programmed.
Cycle through the eight available modes by clicking the tailcap off and on.
The mode sequence is as follows:
Moonlight
High
Low
Medium
Max
SOS
Strobe
Once you find your desired mode, leave that mode on for ten seconds, and
the light will flash again, confirming the mode has been memorized. To
cancel programming before it flashes, turn off the light for three seconds.
.
Beacon