Daintree GE GERDXNLG15 Installation Manual
Browse online or download pdf Installation Manual for Lighting Equipment Daintree GE GERDXNLG15. Daintree GE GERDXNLG15 9 pages. Light guide forming instructions
Also for Daintree GE GERDXNLG15: Manual (2 pages)
Print Page
Tetra
Contour
®
Light Guide Forming Instructions
GEXNLG15, GERDXNLG15, GEPOXNLG15, GEYAXNLG15, GELGXNLG15, GEGLXNLG15, GEBLXNLG15
The light guide is made to use together with the light engine. Please ensure you read the installation guide and warnings
of light engine before installing.
Preparation
Remove the protective film
1
from the light guide.
Silicone Bend-Aid
4
Fill the entire light guide
channel with the GEXNBA
Silicone Bend-Aid(s) and press
into place. Bend-Aid must be
installed prior to heating and
forming. The GEXNBA Silicone
Bend-Aid is reusable.
WARNING
Mark the light guide at the
2
required length, adding 0.5 in.
(13mm) for every 16 in. (406mm)
to account for shrinkage during
the forming process.
DO NOT heat and form the light guide with the light engine installed.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment . This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
This Class [A] RFLD complies w i t h the Canadian standard ICES-005. Ce DEFR de la classe [A] est
conforme à la NMB-005 du Canada.
Installation Guide
SIGN025 | EU | GE2025-0587
Cut the light guide to the
3
required length using a
hacksaw, chop saw (cross cut or
veneer blade only), band saw,
or other appropriate plastic
cutting tool.
WARNING