Daintree GE Tetra GEAM2465-W1 Installation Manual - Page 3

Browse online or download pdf Installation Manual for Lighting Equipment Daintree GE Tetra GEAM2465-W1. Daintree GE Tetra GEAM2465-W1 6 pages. Led lighting system

Print Page

Tetra

Atom

Layout Modules

Before you begin, clean

surfaces and remove all

debris from the inside of

the channel letter.Clean the

surfaces with a 50:50 mixture

of isopropyl alcohol (IPA) and

water and let dry.

Use the double stick tape or

electrical grade RTV silicone

to fix LED module within the

channel letter.

Measure and cut Tetra LED

strip to the appropriate

length for each letter. Cuts

can be made between any of

the modules.

Drill a 1/4-inch (6.4 mm)

hole near the LED strip and

grommet the hole for supply

wire access.

NOTE: For halo-lit applications LED modules should be mounted on

UL recognized clear acrylic or polycarbonate. The light output from

the LED system should be directed back into the sign enclosure. This

will allow for uniform backlighting of the sign and will provide simple

mounting.

Installation Guide

Do not

press lens

Remove tape backing and stick

LED modules into place. When

using tape apply approximately

15 psi pressure on the module

(avoid the lens dome surface) for

5 seconds, full bonding strength

after 24 hours. Continue until you

have reached the end of the strip.

Remove all the debris from the

inside of the channel letter and

replace the sign face.