DSC 5800VHK User Manual - Page 2
Browse online or download pdf User Manual for Security System DSC 5800VHK. DSC 5800VHK 4 pages. 5.8 ghz wireless av/alarm kit
Print Page* Panel View:
○
1
1. DC+12V IN: Power input DC+12V/500mA.
2. ALARM OUT: Once triggered, the built-in buzzer and alarm remains on for a 20-sec time. This port could
be connected to alarm devices, e.g.: Siren, Flashing Unit.
3. AUDIO OUT: RCA female for audio signal output.
4. VIDEO OUT: BNC female for video signal output.
5. POWER/STATE LED: Indicated to power on or ARM and RF link status.
6. DISARM: Alarm ON / OFF selection.
7. CH SELECT (A B C D): 5.8GHz transmission channel selection.
8. ID AND ALARM MUTE: ID address setting is use for paring with transmitters (TX unit).
It must be make the same code setting to link transmitter and receiver each other. The alarm mute function
is use for muting built-in buzzer and disables the alarm output at RX unit.
9. ANT: RP-SMA connector for connected to 5.8 GHz antenna and built-in 3.3V / 25mA bias-tee circuit for an
active antenna.
*
REMARK: When the frequency channels have the interference, adjust antenna or change the channel of transmitter
and don't close to 802.11 a/b/g AP router and other 5.8GHz devices. (Note: Please keep 3 ~ 5 meter away)
11/5/2009
MODEL: DSC- 5800VHK(
RX unit
○
○
○
2
3
4
Indications
Power On
ARM
RF Loss/Waiting TX Link
Bit 1
Bit 2
Bit 3
(Pairing with TX)
0
0
0
0
0
1
0
1
0
0
1
1
1
0
0
1
0
1
1
1
0
1
1
1
(1 = SW ON, 0 = SW OFF)
:SK2-5800A)
○
○
5
6
Power/State LED
On
High speed Flashing
Low speed Flashing
ID Address
Bit 4
0
0
1
1
2
3
4
5
6
7
2
○
○
○
7
8
9
Alarm Mute
ON
OFF