DSC PC 5010 Quick Manual - Page 15

Browse online or download pdf Quick Manual for Security System DSC PC 5010. DSC PC 5010 20 pages.
Also for DSC PC 5010: Instruction Manual (10 pages)

Print Page

• Each person should know of a predetermined assembly point where everyone can be accounted

for i.e.: across the street or at a neighbour's house. Once everyone is out of the building, call the

Fire Department.

• A good plan emphasizes quick escape. Do not investigate or attempt to fight the fire, and do not

gather belongings or pets as this wastes valuable time. Once outside, do not re-enter the house.

Wait for the fire department.

• Write the fire escape plan down and rehearse it frequently so that should an emergency arise,

everyone will know what to do. Revise the plan as conditions change, such as the number of

people in the home, or if there are changes to the building's construction.

• Make sure your fire warning system is operational by conducting weekly tests (see "Fire Alarm

Operation" on page 14). If you are unsure about system operation, contact your installing dealer.

• We recommend that you contact your local fire department and request further information on fire

safety and escape planning. If available, have your local fire prevention officer conduct an in-

house fire safety inspection.

Maintenance

With normal use, the system requires minimum maintenance. The following points should be observed.

1. Do not wash the security station with a wet cloth. Light dusting with a slightly moistened cloth should

remove normal accumulations of dust.

2. The battery/ bell test is designed to determine battery condition. We recommended, however, that

the stand-by batteries be replaced every three years.

3. For other system devices such as smoke detectors, passive infrared, ultrasonic or microwave motion

detectors or glassbreak detectors, consult the respective manufacturer's literature for testing and

maintenance.

Digital Security Controls Ltd. warrants that for a period of twelve months from the date of purchase, the

product shall be free of defect in materials and workmanship under normal use and that in fulfilment of

any breach of such warranty, Digital Security Controls Ltd. shall, at its option, repair or replace the

defective equipment upon return of the equipment to its repair depot. This warranty applies only to

defects in parts and workmanship and not to damage incurred in shipping or handling, or damage due

to causes beyond the control of Digital Security Controls Ltd. such as lightning, excessive voltage,

mechanical shock, water damage, or damage arising out of abuse, alteration or improper application

of the equipment.

The foregoing warranty shall apply only to the original buyer, and is and shall be in lieu of any and all

other warranties, whether expressed or implied and of all other obligations or liabilities on the part of

Digital Security Controls Ltd. This warranty contains the entire warranty. Digital Security Controls Ltd.

neither assumes, nor authorizes any other person purporting to act on its behalf to modify or to change

this warranty, nor to assume for it any other warranty or liability concerning this product.

In no event shall Digital Security Controls Ltd. be liable for any direct, indirect or consequential

damages, loss of anticipated profits, loss of time or any other losses incurred by the buyer in

connection with the purchase, installation or operation or failure of this product.

WARNING: Digital Security Controls Ltd. recommends that the entire system be completely tested

on a regular basis. However, despite frequent testing, and due to, but not limited to, criminal

tampering or electrical disruption, it is possible for this product to fail to perform as expected.