DSC PC1550 Instruction Manual - Page 3

Browse online or download pdf Instruction Manual for Security System DSC PC1550. DSC PC1550 12 pages. 4 digit master code
Also for DSC PC1550: Instruction Manual (17 pages), Instruction Manual (17 pages), Instruction Manual (17 pages), Instruction Manual (9 pages), Instruction Manual (17 pages)

Print Page

ENTRY DELAY OFF ARMING

If you wish to arm your system and eliminate

the entry delay, enter [*][9] before your access code. The "Armed" light will flash

as a reminder that the system is armed and has no entry delay. An entry through

any zone programmed as a delay zone will create an instant alarm.

e.g. To arm without entry delay.....Press [[*][9][Access Code]

DISARMING

Enter the premises only through the door indicated by your

installer as the entry/exit door. The keypad sounder will be ON. Go to the keypad

and enter the [4 digit access code]. If an error is made entering the code, press

the [#] key and enter the code again. The "Armed" light will go out and the

keypad sounder will stop. A correct access code must be entered before the

allowed entry time expires. The entry delay time may be changed by the installer.

If an alarm occurred while the panel was armed, the "Memory" light and the light

for the zone which caused the alarm will start to flash and will continue flashing

for 2 minutes. At the end of 2 minutes, the keypad lights will stop flashing and the

keypad will return to the normal Ready condition.

If you return home and find an alarm has occurred while you were away, it is

possible that an intruder may still be on the premises. Go to a neighbor's and if

your system is monitored, call the monitoring station. They will advise what action

has been taken as a result of the alarm and whether the premises are safe to

enter. If your system is not monitored, call the local police to investigate.

ALARM MEMORY DISPLAY

If the "Memory" light is on, an alarm has

occurred since the last time the panel was armed. The alarm memory will

automatically be displayed when the system is disarmed (see Disarming).

Press the [*] then [3] keys to display which zone caused the alarm.

The alarm memory will be cleared when the panel is re-armed. Press the [#] key

to return to Ready.

Bypassed zones do not cause an alarm. Use zone

bypassing when access is needed to part of the protected area. Also, damaged

wiring or contacts on a zone may be temporarily bypassed until repairs can be

made so that the panel can be armed.

To bypass zones, enter [*][1][Access Code] and the zone numbers to be

bypassed. i.e. [1] for zone 1, [6] for zone 6. If the [0] key is pressed instead of a

zone number, all zone bypasses will be removed. If the [9] key is pressed, the

last group of zones which was bypassed will be recalled. Press [#] to return to

Ready.