DSC PC255O Instruction Manual - Page 10

Browse online or download pdf Instruction Manual for Security System DSC PC255O. DSC PC255O 17 pages.
Also for DSC PC255O: Instruction Manual (8 pages), Frequently Asked Questions Manual (18 pages)

Print Page

PROGRAMMING ADDITIONAL ACCESS CODES

Up to 15 access codes in addition to the Master Code can be entered from the

keypad.

Enter [ ][5][Master Code]. The "Program" light will flash and the zone lights will

show which of codes 1 to 8 have already been programmed. To enter a new

code or change an existing code, first press the code number (1 to 8) and then

enter your [4 digit] code. To erase a code, press [

] instead of a [4 digit]

code. Note that the [ ] and [#] keys cannot be used in a code.

For codes 9 to 16, after entering [ ][5][Master Code], press [9]. The "Ready",

"Armed"and "Program" lights will flash and the zone lights 1 to 8 will indicate

which of codes 9 to 16 have been entered. As above, to change or enter a code,

select the code by pressing 1 to 8 and then enter your [4 digit] code. Entering

[

] erases a code. Pressing [9] again will change back to codes 1 to 8.

Pressing [#] returns you to ready mode. Access Code 16 ([ ][5][Master

Code][9][8][4 digits]) can be set up by your installer to be used by a maid or

other service personnel one time only. Each time you enter this code, it can be

used to disarm your system but is erased when used to arm the system, ensuring

just one-time access.

QUICK-ARM FEATURE

When the Quick-Arm feature is enabled, the panel may be armed simply by

entering [ ][0] instead of a 4 digit code. The [ ][0] command will not disarm the

panel.

Enter [ ][6][Master Code][4] to turn ON and OFF the Quick-Arm feature. When

the command is entered, the keypad will beep 3 times if the feature is being

enabled and will sound one long beep if the feature is being disabled.

Press [#] to return to Ready.

QUICK EXIT OPTION

This feature, if selected by your installer, allows one exit with the system armed

without affecting its current armed status.

Pressing [ ][0] gives you 2 minutes to exit if you have already armed the system.

This is useful if you want to exit while preserving the protection for someone left

on the premises. Once you have exited, the system will be armed as before. If

the zone is open after 2 minutes or there has been more than one exit, the pre-

alert will sound.

The door chime feature is used, while the panel is disarmed, to provide a tone

from the keypad each time a door or window is opened or closed. The doors and

windows which will provide this indication are programmed by your installer.

Enter [ ][6][Master Code][6] to turn the door chime feature ON and OFF. When

the command is entered, the keypad will beep 3 times if the feature is being

enabled and will sound one long beep if the feature is being disabled.