DAITEM SH601AU Installation Manual - Page 14

Browse online or download pdf Installation Manual for Security System DAITEM SH601AU. DAITEM SH601AU 20 pages. Alarm pendant

Print Page

7. Testing operation and radio coverage in test mode

IMPORTANT: Whatever the command sent by the sliding part or push-button:

• the advantage of the test mode is being able to test the pendant without reducing the radio range and:

- with sounding that lasts a shorter time: control panel (3 s.), siren (5 s.)

- without triggering telephone transmission,

• the siren's sounding power can cause hearing disorders and the necessary precautions must therefore be taken

during testing.

1. Switch the control panel (or dialler) to test mode:

installer code

2. Test operation:

Each command sent when the push-button is pressed for

more than 2 s (red or green ﬂashing) is preceded by a "battery

status test" which brieﬂy causes the LED to light up red.

• Press the push-button for 2 seconds (or pull on the sliding

part), the pendant LED ﬂashes for roughly two seconds

before going out.

If the sliding part remains open, the message is re-transmitted

every 15 min.

• Use the table opposite to check the control panel response.

The dialler, in test mode, responds with a sharp beep and

does not trigger transmission whatever the command sent by

the pendant.

Command

description

"beep, test mode"

Alarm

Silent Alarm

(factory setting)

Local call

Fire alarm (1)

Door bell (1)

Audible signal (1)

(1) "Comfort" type command (green). Only possible

Control panel response

in test mode

sounding: 3 s.

"beep, alarm, command

n°"

"beep, emergency call,

command n°"

"beep, fire alarm,

command n°"

"ding, dong, command n°"

"beep, beep, beep, beep"

with push-button (see chapter on "Advanced

programming").