DAITEM SH274AX Installation Manual - Page 2

Browse online or download pdf Installation Manual for Security Sensors DAITEM SH274AX. DAITEM SH274AX 4 pages. Contact detector
Also for DAITEM SH274AX: Installation Manual (13 pages)

Print Page
3. Programming
IMPORTANT: during recognition programming it is not necessary to place the product near the control panel, it is advised to
place it at least 2 m away.
Programming enables contact detectors to be recognised by the control panel.
1. To programme contact detectors the control panel must be in installation mode. If it is not, you will require the user's
master code, press:
master code
(0000 factory default)
2. Programme the device as follows:
then
Press and hold the
Press
then
#
on
*
"test" button until
the control panel
the control panel
keypad
responds
IMPORTANT: the control panel indicates an error by emitting 3 short beeps. When this happens programming should be
carried out again.
Example: programming of 1st detector allocated to Group 2 with immediate triggering.
then
10 s max.
4. Installing
4.1 Choosing the best place
IMPORTANT
• Make sure there is a distance of at least 2 meters between
each product, except between 2 detectors.
• When the detector is fixed to a metal support, insert a
20 mm thick wooden or plastic spacer between the base
and the metal frame.
4.2 Fixing method and installing the magnet holder
Fix the back plate to the wall using 2 screws suitable for wall fixing.
When the entrance is closed the magnet holder must be positioned opposite the built-in contact less than 5 mm away from it.
then
engineer installer code
(1111 factory default)
"detector X"
"group ?"
10 s max.
The control panel waits for a
group to be chosen (from 1 to 8)*.
Choose the groups by pressing
the corresponding numeral on the
control panel keypad
"detector 1"
"group ?"
"beep, installation
"time delay?"
*
to
to
* according to the
type of control panel
Choose the type of triggering:
0: immediate • 1: delayed
2: combined
Use the control panel keypad
to select the type
"time delay?"
"beep, detector 1
group 2,
immediate"
IMPORTANT: the control panel indicates
an error by emitting 3 short beeps. When
this happens programming should be
carried out again.
The contact detector must be placed:
• inside the protected area,
• preferably on the door frame of the entrance to be
protected at least 1 m above ground level,
• far away from any sources of interference (electricity meter,
metallic frame, etc.),
• on a flat surface.
2
mode"
"beep, detector X,
group Y immediate
(or delayed
or combined)"
The control panel
gives a voice
message to confirm
detector programming