DSC PowerSeries PK5516 Instruction Manual - Page 11

Browse online or download pdf Instruction Manual for Security System DSC PowerSeries PK5516. DSC PowerSeries PK5516 20 pages. Power pk55xx/rfk55xx-433 series
Also for DSC PowerSeries PK5516: Installation Instructions Manual (9 pages)

DSC PowerSeries PK5516 Instruction Manual

Access Code Programming

In addition to the Master Access Code, you can program up to 47 additional User Access codes.
Press
, plus your Master Access Code. The Program or System indicator will begin to flash, and
the Armed ( ) indicator will turn on.
Enter the 2-digit number to be programmed (i.e. 06 for user access code 6; enter 40 for the Master
Access Code).
When using the PK5500/RFK5500, use the
select. Enter the new 4 or 6-digit access code, or press
plete, enter another 2-digit code to program or press
For systems using multiple partitions/areas, access codes can be assigned to specific or multiple parti-
tions/areas. Please contact your alarm company for details.
The access codes have programmable attributes which allow zone bypassing, remote access using
the ESCORT5580TC or one-time use activation.

Access Codes

,
[
][5][Master Code] (when disarmed)
The [,][5] User's Programming command is used to program additional access codes.
Master Code (Access Code 40)
grammed.
Supervisor Codes
ming section. However, these codes can only program additional codes which have equal or lesser
attributes. Once programmed, the Supervisor Codes receive the Master Code's attributes. These
attributes are changeable. Any User Code can be made a supervisor code by enabeling User Code
Attribute 1 (please see below for details).
Duress Codes
- Duress codes are standard User Codes that will transmit the Duress Reporting Code
whenever the code is entered to perform any function on the system. Any User Code can be made a
Duress Code by enabeling User Code Attribute 2 (please see below for details).
NOTE: Duress codes are not valid when entering [
NOTE: Access codes cannot be programmed as a duplicate or as a "Code +/- 1".

User Code Attributes

1. The default attributes of a new code will be the attributes of the code used to enter
whether it is a new code or an existing code being programmed.
2. System Master (Code 40) has Partition Access for all partitions, as well as Attributes 3-4 ON by
default.
NOTE: These attributes are not changeable.
Inherent Attributes (all codes except installer and maintenance)
Arm / Disarm
- Any Access Code with Partition Access enabled will be valid for arming and disarming
that partition.
Command Outputs ([
Access Code entry, any Access Code with Partition Access will be valid for performing the [,][7][1-
4][Access Code] functions on that partition.
Programmable Attributes ([
1. Supervisor Code
2. Duress Code
3. Zone Bypassing Enabled
4. ESCORT Access
5. For Future Use
6. For Future Use
7. Bell Squawk upon Arming/Disarming
8. One Time Use Code
- The Master Code can only be changed by the Installer, if pro-
- These codes are always valid when entering the
,
,
][7][1], [
][7][2], [
,
][5][Master/Supervisor Code][99][Code])
keys to find the specific code and press
to erase it. When programming is com-
to exit.
,
,
][5], [
][6] or [
,
,
][7][3], and [
][7][4])
9
User Code Program-
,
][8] sections.
- If these outputs require
to