FOXFURY 900-1090S Product Manual
Browse online or download pdf Product Manual for Lighting Equipment FOXFURY 900-1090S. FOXFURY 900-1090S 2 pages.
Print PagePlease read below before using your CS Scan flashlight as
it relays beneficial operating and safety information.
Part Number
Product Name
900-1090S
CS Scan
PHYSICAL CHARACTERISTICS
Aluminum 6061-T6 hard anodized housing with TPR
bumpers
Model
CS Scan
OPERATIONAL INSTRUCTIONS
•
Power - Press the ON/OFF button located on the end
cap to turn on the center white light. Power will remain
on until Power button is pressed again.
•
Manual Mode - Press the Manual Mode button located
on the head to manually cycle through the various
LEDs each time the button is pressed. The cycle starts
with white (center) then continues clockwise through
365nm, 395nm, 450nm, and 470nm.
•
Scan Mode - Press the Scan mode button located
on the head to cycle through the various LEDs:
365nm, 395nm, 450nm, and 470nm. Once the desired
wavelength is reached, press the Manual Mode button
CS SCAN PRODUCT MANUAL
Exterior Color
Silver
End Cap
Handle
Head
Charging Port
Power Button
Manual Mode
Button
Scan Mode
Button
Dimensions
Length: 10.75 in (274 mm)
Head Diameter: 3.8 in (96 mm)
Handle Diameter: 1.9 in (48 mm)
Weight: 3.4 lbs (1.5 kg)
to remain on that wavelength. Press the Scan Mode
button again to continue the cycle.
NOTE: White light is only available when using the Power
button or Manual Mode button.
BATTERY LIFE
Battery life is expected as follows:
Full Power
Reserve Power
*Battery life may vary according to mode selected, battery quality and
prevailing ambient conditions.
CHARGING THE BATTERIES
The CS Scan is rechargeable. To charge the unit, plug the
supplied charger (100-240VAC, 50/60 Hz) into the charging
port located on the end cap near the ON/OFF switch.
•
Approximate charge time: 4 hours
•
While connected to the AC adaptor, the GREEN light
on the end cap of the CS Scan is ON. Its function is to
advise that you are attempting to charge.
•
The AC adaptor also has a light which is GREEN when
plugged into an outlet. As soon as you connect it to
the CS Scan for charging, the light turns RED. A solid
GREEN light on the AC adaptor means the light is fully
charged.
NOTE:
Continuously charging (leaving the unit plugged in) could
damage the battery and lead to a decreased battery life.
Please disconnect the unit once it is fully charged.
4 to 6 hours
Up to 6 hours