FOXFURY Nomad 600-200-900 Replacement

Browse online or download pdf Replacement for Battery Pack FOXFURY Nomad 600-200-900. FOXFURY Nomad 600-200-900 2 pages. Battery for nomad 360, t32 and t56

Print Page
NOMAD
360, T32 AND T56 BATTERY REPLACEMENT (P/N 600-200-900)
®
REMOVING THE BATTERY TUBES | 15 MINS
The Nomad
360, T32 and T56 uses 12 Battery Tubes. Repeat the following steps
®
six (6) times in order to replace all 12 Battery Tubes.
1
BATTERY COVER(S) ON
3
FOR P/N 200-900, 200-900-TC, 200-9T32, 200-9T56
(APPROX)
2
BATTERY COVER
REMOVED
4
BATTERY TUBES
REMOVED
Make sure the Nomad
is OFF and UNPLUGGED before starting.
®
1.
Open the Folding Tripo-Scope
1
®
locate a Battery Cover.
Use a Phillips Head ( + ) Screwdriver to remove the four (4) screws that hold the
2
2.
Battery Cover. Once the screws are removed, pull the Battery Cover off and set
it aside.
IMPORTANT: There are two (2) Battery Tubes (the UPPER and LOWER)
under each one (1) of the Battery Covers.
Once the Battery Cover is removed, the Battery Tube is accessible. Start with the
UPPER battery first.
3
3.
At the BOTTOM of the UPPER Battery Tube, there will be a red (positive)
Battery Tube Cap. Place an index finger on it, push the red Cap up, and pull it
forward (this should help the top portion of the Battery Tube to easily slide out of
the Battery Compartment). This action is similar to removing a AA battery from
any generic battery holder.
To easily remove the Battery Tube from the Nomad
the red Battery Tube Cap up and pull it out (at a 20º angle).
NOTE: The wiring for the positive ( + ) and negative ( – ) Caps will remain
attached to the Nomad
®
Body while the Battery Tube is pulled out of the
Battery Compartment.
Once the UPPER Battery Tube is removed, repeat steps 1–3 for the LOWER Battery
Tube. NOTE: While pulling the UPPER Battery Tube out, the LOWER Battery Tube
may come out at the same time.
4
4.
Remove the Battery Tube Caps (red and black) from each end of the Battery
Tube. This can be done by simply popping the Battery Tube Cap off with one
thumb.
DO NOT pull the Battery Tube Caps by the wires.
REPEAT STEPS 2– 4 FOR THE REMAINING BATTERIES.
Legs so they are locked and deployed. Then,
®
Body, it is best to push