Absolute Measurement CLT Instruction Manual - Page 4

Browse online or download pdf Instruction Manual for Transducer Absolute Measurement CLT. Absolute Measurement CLT 9 pages.

Print Page

Transducer Instruction Manual

Range:

Ultra

Type:

CLT

Revision:

V1.0

2.2

Installation Precautions

To ensure proper installation and operation of the tension system, the following steps should be

performed in sequence - always install, orientate and firmly bolt down the transducer BEFORE installing

the tension sensing roller.

Welding. Unplug the cable connector from the transducer before any electric welding is undertaken on

the machine.

Transport. It is recommended that the tension sensing roller is removed from the transducer before the

machine is transported to prevent excessive shock being transmitted through to the transducer.

Failure to carry out these precautions could seriously damage the transducer and invalidate the warranty.

2.3

The mounting surface for the transducer should be rigid, flat and clean. Prepare the machine frame or

mounting surface by removing any loose paint, rust, scale, burrs etc.

2.4

Rotate the transducer so that the tension resultant force is in line with the "LOAD LINE" label as shown

alongside, then SECURELY tighten the mounting bolt. The cable connector should bisect the web wrap

angle.

The mounting bolt must not bottom in the transducer, the depth of the mounting hole in the CLT-SCM

transducer is 14mm. Check that there is clearance between the mounting bolt and the bottom of the

transducer mounting hole. Fixings are available from CMC Controls if they have not been supplied with

the order, request Part Number 0594 or 0595.

_____________________________________________________________________________________________________________________

Absolute Measurement Ltd. (T/A CMC Controls)

t: (0) 1732 763278

| e:

Unit 19

| Silver Birches Business Park | Aston Road | Bromsgrove | B60 3EU

| w: absolutemeasurement.co.uk