Foxfury Lighting Solutions Signature Series Instruction Manual - Page 3
Browse online or download pdf Instruction Manual for Headlamp Foxfury Lighting Solutions Signature Series. Foxfury Lighting Solutions Signature Series 5 pages. Intrinsic safety headlamp
Print Page
BATTERY PACK MAINTENANCE:
DEALING WITH CORROSION FROM LEAKING BATTERIES
Battery leakage may cause "corrosion" to build in the battery pack contacts, causing light not to function properly.
In case of the presence of Corrosion on the battery pack contacts, please follow the suggested steps listed below:
1.
Mix 50% vinegar and 50% water.
2.
Remove batteries from the battery pack.
3.
Pour the combination into the battery pack and let soak for 5 minutes.
4.
Remove fluid from inside the battery pack and dry it properly with a paper towel, and a blow drier set to
Medium or Low heat settings, held 6" or further away (make sure no liquid residue is left inside battery pack).
5.
Replace your batteries and test the light's function.
6.
Repeat as needed.
7.
For the metal disc, inside the cap, if scrubbing is needed; a moistened vitamin C tablet can be used. Rinse well
and dry as noted above.
8.
After using a set of batteries to the point of exhaustion, remove them as soon as possible and replace them
with new ones – to prevent outgassing from causing corrosion.
NOTE: Corrosion from leaking batteries or battery outgassing is not covered by warranty.
BATTERIES:
- Inside the battery case cavity is a set of orientation markings for battery polarity. Install both battery pairs as shown,
one pair on top of the other.
- The warmer the batteries remain while in use, the longer their life (room temperature to body
temperature is ideal).
- Depending on temperature and battery brand used, an average of eight (8) hours performance is
expected with each set of fresh batteries.
- Do not mix different brands of batteries, or new batteries with used batteries.
- Respect the polarity of the batteries when installing them in the battery pack. Failing to do so may result in gaseous
emissions, and/or caustic chemicals from leaking batteries. With just one battery installed backwards, the unit will
function for a much shorter time than normal, the reversed battery may become hot and may emit gas or leak
caustic chemicals.
AVAILABLE ACCESSORIES:
Black Silicone Strap, p/n 600-027
-
3D Fury Glow Silicone Strap, p/n 600-026
-
Elastic Strap, p/n 60-019
-
Helmet Hold Down (set of 2), p/n 50-023
-
Overhead Strap, p/n 600-002
-
!
Warnings
WARNING: To reduce the risk of ignition of a flammable or explosive atmosphere, batteries must be
changed only in a location known to be non-hazardous.
WARNING: Respect the polarity of the batteries when installing them in the battery pack. Failing to do so
may result in gaseous emissions, and/or caustic chemicals from leaking batteries.
WARNING: To reduce the risk of explosion, do not mix old batteries with new batteries, or mix batteries
from different manufacturers.
WARNING: This unit contains no user serviceable parts in the electrical circuits. Do not attempt repairs to
the battery pack, cable, or headpiece printed circuit board. The unit must be returned to the factory for all
electrical or PCB coating repairs.
WARNING: When a fresh set of batteries are installed, if all 24 LED's do not light up. DO NOT use the
product in a hazardous area, return the unit for repair
FF261-x INSTRUCTION Sheet_5_14
Page 3