Anslut 004584 Operating Instructions Manual - Page 15

Browse online or download pdf Operating Instructions Manual for Lantern Anslut 004584. Anslut 004584 18 pages. Solar cell lighting

Print Page

SAFETY INSTRUCTIONS

•
Do not expose the battery to naked flames
or high temperatures.
•
The lamp and solar panel are weather
resistant, but do not immerse them in
water or any other liquid.
•
Do not look directly into the lamp when it
is switched on.
•
Do not use the lamp if the chimney is
damaged.
•
The light sources are not replaceable.
If the lamp stops working it must be
discarded.
Rechargeable batteries
IMPORTANT:
When replacing batteries – only use
rechargeable batteries.
•
Always buy the correct size and type of
battery intended for this purpose.
•
Remove the battery from the product if it
is not going to be used for some time.
•
Recycle used batteries in accordance with
local regulations.
Symbols
Approved as per
applicable directives.
Recycle discarded product
as electrical waste.

TECHNICAL DATA

Battery
Luminous flux
6 V / 2000 mAh Ni-MH
1500 lm
DESCRIPTION
1.
Floodlight
2.
Star knob
3.
Mounting bracket
4.
Solar panel
FIG. 1
MOUNTING
1.
Make sure to put the solar panel where
it will get as much sunlight as possible.
Note that trees and buildings etc. can put
the solar panel in the shade and affect its
charging capacity. Adjust the solar panel
by undoing the wing nut, putting the
panel in the required position and then
tightening the wing nut.
FIG. 2
2.
Mark out where to drill the holes for
the solar panel. Check that there are no
cables or conduits under the markings.
Drill holes for the supplied plugs and
screws. Put the plugs in the drilled holes
and screw on the solar panel with the
screws.
FIG. 3
3.
Place the mounting bracket for the
floodlight at a height of 180 to 240 cm
above the ground on a stable surface
that can support the weight of floodlight
and which is not exposed to vibrations or
wind. The floodlight must be high enough
to detect movement and to disperse the
light.
FIG. 4
4.
Mark out where to drill the holes for the
mounting bracket. Check that there are
no cables or conduits under the markings.
Drill holes for the supplied plugs and
screws. Put the plugs in the drilled holes
and screw on the solar panel with the
EN
15