Foxfury Lighting Solutions 200-900-TC Product Manual - Page 11

Browse online or download pdf Product Manual for Light Fixture Foxfury Lighting Solutions 200-900-TC. Foxfury Lighting Solutions 200-900-TC 20 pages.
Also for Foxfury Lighting Solutions 200-900-TC: Quick Start Manual (6 pages)

Print Page
Foxfury Lighting Solutions 200-900-TC Product Manual
1.
1
Set the Nomad
Protective Light Cap and twist the Locking Sleeve to the right (
slide upwards (
the left (
). The Folding Tripo-Scope
C
(
).
D
2
2.
Unfold each Tripo-Scope
the Leg Locks (see the "Reference Guide" on pg. 3 for location).
3
3.
Pull the Light Head up from inside the Locking Sleeve. Keep the Light
Panels as they are for a 360 configuration or, open the Light Panels for a
Directional configuration. Then, based on preference or need, adjust the
Sliding Diffuser Lens to either Area or Spot lighting (see "Sliding Diffuser
Lens" on pg. 8 for more information).
4
4.
Adjust the angle and swivel position of the Light Head by loosening the Tilt
Adjustment Knob to the desired orientation and then re-tighten.
Light Head placement and adjustment can be made easier by
tightening the Hinge Screw (located near the Tilt Adjustment Knob).
5.
5
Elevate the Light Head to desired height by raising the Tripo-Scope
Tighten the Tripo-Scope
desired height.
IMPORTANT: To reposition, loosen the Tightening Rings, bring the
Tripo-scope
pick up and move the position of the whole Nomad
TRY TO TURN THE TRIPO-SCOPE
OTHER. This can cause permanent damage.
6.
6
On uneven ground, adjust each Tripo-Scope
Lift the leg off the ground, and then, using both thumbs, press and hold
both of the Leg Extension Release Tabs until the Leveling Leg Extensions
(located at the end of each of the Tripo-Scope
Retract the Leveling Leg Extensions in the same manner.
Fine adjustment can be made by turning the Leveling Leg Extensions.
Use the Level Bubble for reference.
In case of heavy wind or extreme weather conditions, attach a sand
bag, or equivalent weight, to the concealed Anchor Strap (see the
"Reference Guide" on pg. 9 for location).
THE NOMAD
IS NOW READY FOR USE!
®
down vertically , on a flat surface, as shown. Open the
®
). While still holding the Locking Sleeve up, twist it back to
B
Leg and make sure they are locked in place by
®
Tightening Rings (clockwise) to hold the poles at
®
Poles down again, and turn the Light Head OR physically
®
Legs are now accessible to deploy
®
POLES AGAINST EACH
®
Leg individually , as necessary .
®
Legs) are released.
®
) and
A
Poles.
®
360. DO NOT
®
11