Foxfury Lighting Solutions NOMAD T56 Quick Start Manual - Page 4

Browse online or download pdf Quick Start Manual for Light Fixture Foxfury Lighting Solutions NOMAD T56. Foxfury Lighting Solutions NOMAD T56 6 pages.
Also for Foxfury Lighting Solutions NOMAD T56: Product Manual (20 pages)

Print Page

Foxfury Lighting Solutions NOMAD T56 Quick Start Manual

INSTALLING THE BATTERY TUBES | 30 MINS ESTIMATED

Installing the Nomad

them, but in reverse order.

LOWER BATTERY TUBE

WARNINGS

Be sure to check polarity [positive ( + ) and negative ( – )] when installing the

Battery Tubes.

Replace ALL Batteries with new ones at the same time.

Start with the LOWER Battery Tube. Attach the black Cap to the

NEGATIVE end of the Battery Tube. While holding the Cap in place,

reinsert it into the Battery Compartment.

While still applying pressure to the bottom Cap, attach the red Cap to the

opposite end (POSITIVE end) of the Battery Tube. Once secure, push

down again and slide the Battery Tube back into place in the Battery

Compartment.

IMPORTANT: Be sure to place the red and black wires directly behind

the Battery Tube before re-installing it into the Battery Compartment.

This will prevent the wires from being damaged, and it will help the

Battery Tube go back into place easier.

Once the Battery Tubes are installed, test the Nomad

turns ON. If it does not, check the Battery Tubes for any connection

errors with the positive ( + ) and negative ( – ) ends. Then, place the Battery

Cover back over the Battery Tubes and tighten the four (4) screws into

place.

Battery Tubes follows the same procedures as removing

(POSITIVE + )

BATTERY TUBE PLACEMENT WHILE INSTALLED

(HORIZONTAL VIEW)

RED CAP

UPPER BATTERY TUBE

to make sure it