DSC ELECTRONICS DF-C 63 Series User Manual - Page 7

Browse online or download pdf User Manual for Control Panel DSC ELECTRONICS DF-C 63 Series. DSC ELECTRONICS DF-C 63 Series 11 pages.

Print Page

DF-C 63XXX & 61XXX Series User's Manual

Version 28.04.2019

3.3 Power ON

Set the „ON / OFF" switch to the ON position to turn on the device. The device is equipped with a soft-start delay which

slowly charges the capacities in the power supply to limit the high inrush currents. After about 10 seconds, the power

supply will switch into stand-by mode.

3.3.1 Stand-By Mode

The output is switched off in stand-by mode and the device is ready to set the desired output values. The displays

show a voltage of 0V and a current of 0A, which corresponds to the actual values at the output.

Press the SET button once to enter the setup menu.

Press the SET button once

- FREQUENCY display flashes -> Frequency setting

Press the SET button 2x

- VOLTAGE display flashes -> Voltage setting

Press the SET button 3x

- VOLTAGE display flashes -> FLOAT + percentage setting (default 10%)

Press the SET button 4x

- VOLTAGE display flashes -> FLOAT- percentage setting (default -10%)

Press the SET button 5x

- CURRENT display flashes -> Setting of Over Current Protection value

(In the range 0 - max. output current of the power supply / max. 0 - 50A)

Press the SET button 6x

- Save settings, back to stand-by mode

3.3.3 Setup Menu (CV Version) DF-C61XXX

Press the SET button once to enter the setup menu.

Press the SET button once

- FREQUENCY display flashes -> Frequency setting

Press the SET button 2x

- VOLTAGE display flashes -> Voltage setting

Press the SET button 3 x

- CURRENT display flashes -> setting of the Over Current Protection value

(In the range 0 - max. output current d of the power supply / max. 0 - 50A)

Press the SET button 4x

- Save settings, back to stand-by mode

3.3.4 Setting the output values for constant current sources of the DF-C series (CC version)

Constant current sources of the DF-C series which work in CC mode have no setup menu and a simplified Control

panel. If you are in stand-by mode (output OFF), values can be entered directly using the arrow keys, saving is not

necessary.

3.3.5 Voltage Range Setting (LV / FS)

Press the LV / FS key to switch between the voltage ranges, the currently set voltage range is displayed on the

frequency display for 3 seconds with L for LV and F for FS. Normally the range is LV for 0 - 150V and FS for 0 - 300V,

this may differ for custom-made devices.

DSC-Electronics Germany • Georgstraße 36 • 53111 Bonn