DSE DK-WP2 Owner's Manual

Browse online or download pdf Owner's Manual for Security Camera DSE DK-WP2. DSE DK-WP2 4 pages. Camera and vcr in wall clock

Print Page

OWNER'S MANUAL

DK-WP2

Camera and VCR in wall clock

Product description

DK-WP2 is a wall clock that contains a hidden camera with video recorder.

The product is also equipped with a highly sensitive microphone can sense very clearly all the

sounds of the environment, including phrases spoken softly in a medium sized environment.

DK-WP2 can operate connected to a power outlet or powered from its own internal battery.

Operating as a real watch

To avoid arousing any suspicion of the DK-WP2 is a real working clock. You must enter a AA

battery (not included) in the rear seat and adjust the time with the wheel, as with a normal wall

clock. The battery that you

fit for

clock has no function in the power of the camera.

Supply

DK-WP2 can run either on AC power or battery

power.

The supply

current

guarantees

Obviously shooting range

without

but limits

It needs an outlet nearby where

insert 220V / 5VDC supplied adapter.

Alternatively, it is possible to use only the power supply to recharge the battery and then to

operate the apparatus in an autonomous way.

Charging the internal battery

DK-WP2 is equipped with a 4200 mAh built-in battery that allows the DVR to record for 8

consecutive hours even in the absence of mains power. The battery is always connected so that

you can turn on the DVR with

moment. With battery fully charged, the DVR can also listen for commands for two months before

exhausting the battery.

The battery is charged when supplied, but it has a minimum consumption even if the product is

not used. For this reason it is recommended that as first thing to provide battery charging, just

received the product.

DK-WP2 camera with VCR in wall clock

operation

the

remote control in any

DSE srl - Digital Surveillance Equipment - www.dse.eu

To recharge the battery just connect the power supply to the socket. To avoid that the DVR starts

recording, execute the charging operation without SD card inserted. There are charging reports

finished. The charging stops automatically to its completion that takes place in a few hours.

If the DVR is turned off for a long time and only occasionally used should compete perform a

recharge every month to prevent over-discharge damages the battery.

Inserting the micro SD card

To register you must insert a micro SD card into

the slot on the back of the watch. E 'can use micro

SD card with a capacity of 4 to 128 GB CLASS 10 or

higher. An SD card class 10 has a write speed of

MB / s. Do not use the SD card with a lower rate because it would lead to malfunction. Attention

to the direction of insertion of the SD card that will slide in its seat only with the gold contacts

facing downwards, as shown in the figure. The SD card should be pushed into the slot with the

nail until you feel the retaining snap. To pull it must not pull it outward, but push again until you

hear the unlocking.

The package does not include any Micro SD card, or the SD card reader for your computer that

you must purchase separately.

LED and TV out

DK-WP2 is also equipped with a rear marking LED

and video output to which you can connect an

external monitor via RCA cable supplied (see

below).

The signaling LED is very important because it makes you understand the status and this way we

can know that commands impart.

STATE OF THE LED

SOLID GREEN

3 FLASHING RED LENS

2 FLASHES GREEN LENSES

3 FLASHING RED FAST

GREEN FLASHING

GREEN / RED FLASHING.

1 FLASHING RED

Resolution / archive / overwrite

DK-WP2 is able to record audio and video in Full HD 1080P 1920x1080 @ 30 f / sec. One minute

recording takes up about 100MB so for each GB of SD card capacity can store approximately 10

minutes of continuous recording. A 32GB SD card can hold more than 5 hours of video, a 128GB

over 20 hours. Obviously it is advisable to use the recording of motion detection, where possible,

in order to record only

images

significant and not occupy

unnecessarily memory when no action takes place in front of the lens.

Document: DK-WP2-1I6

Page: 1

MEANING

DVR is on the stand-by, waiting for

commands

Registration motion

continuous Recording

off Confirmation

Missing SD card

Failure SD access

Taking photos